Exeo headlight removal SEAT Exeo ST (3R5)

To remove the headlight on a SEAT Exeo ST (3R5), the general process is as follows:
- Open the hood and locate the rear cover of the headlight assembly.
- Remove the headlight rear cover by twisting or unfastening it (often about a 30° turn).
- Disconnect the bulb holder by twisting it around 30 degrees, then pull it out from the headlight mounting seat.
- If you want to remove the entire headlight unit, you will likely need to remove mounting bolts that hold the headlight assembly in place, which are typically accessible inside the engine bay around the headlight or under the bumper.
- Carefully disconnect any wiring harness connectors attached to the headlight unit.
- Once all bolts and connections are undone, the headlight unit can be pulled forward and removed.

Be cautious to avoid damaging clips or wiring during the process. Some trim removal or bumper detachment might be required for full headlight removal depending on the specific model trim and whether it's a halogen or xenon unit.

For bulb replacement only, this rear access and bulb holder twisting method is usually sufficient without full removal.

There are detailed guides and videos available that show this process step-by-step specifically for the SEAT Exeo ST (3R5), which might help with difficult access points or tricky clips.