Disclaimer
How to change windscreen wiper arm on VW Jetta Mk5 (1K) – replacement guide
downloads:
1
Views:
19
Important!
This replacement procedure can be used for:
VW Jetta Mk5 (1K) 1.6, VW Jetta Mk5 (1K) 1.6 FSI, VW Jetta Mk5 (1K) 2.0 FSI, VW Jetta Mk5 (1K) 1.9 TDI, VW Jetta Mk5 (1K) 2.0 TDI 16V, VW Jetta Mk5 (1K) 2.0 TFSI, VW Jetta Mk5 (1K) 2.0 TDI, VW Jetta Mk5 (1K) 1.4 TSI, VW Jetta Mk5 (1K) 1.4 TSI, VW Jetta Mk5 (1K) 2.0 TDI, VW Jetta Mk5 (1K) 2.0 TDI, VW Jetta Mk5 (1K) 1.4 TSI … View more
The steps may slightly vary depending on the car design.
VW Jetta Mk5 (1K) 1.6, VW Jetta Mk5 (1K) 1.6 FSI, VW Jetta Mk5 (1K) 2.0 FSI, VW Jetta Mk5 (1K) 1.9 TDI, VW Jetta Mk5 (1K) 2.0 TDI 16V, VW Jetta Mk5 (1K) 2.0 TFSI, VW Jetta Mk5 (1K) 2.0 TDI, VW Jetta Mk5 (1K) 1.4 TSI, VW Jetta Mk5 (1K) 1.4 TSI, VW Jetta Mk5 (1K) 2.0 TDI, VW Jetta Mk5 (1K) 2.0 TDI, VW Jetta Mk5 (1K) 1.4 TSI … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Windscreen Wiper Arm for Jetta Mk5 (1K) and other VW models
Alternative products

Wire brush
WD-40 spray
Copper grease
Torque wrench
Drive socket # 13
Ratchet wrench
Flat Screwdriver
Universal puller
Fender cover
Replacement: windscreen wiper arm – VW JETTA III (1K2). AUTODOC experts recommend:
- Replace the wiper arms in pairs.
- Don't mix up the wiper arms on the driver's and passenger's side.
- The replacement procedure is the same for both wiper arms.
- Please note: all work on the car – VW JETTA III (1K2) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Remove the windscreen wiper arm nut covers. Use a flat screwdriver. - Step 4
Clean the fasteners of the wiper arms. Use a wire brush. Use WD-30 spray. - Step 5
Unscrew the fasteners of the windscreen wiper arms. Use a drive socket #13. Use a ratchet wrench. - Step 6
Remove the wiper arms. Use a universal puller. - Step 7
Remove the wiper blades. - Step 8Clean the pivots of the windscreen wiper arms. Use a wire brush. Use WD-40 spray.Step 9
Treat the pivots of the windscreen wiper arms. Use copper grease. - Step 10
Attach the wiper blades to the new arms. - Step 11
Reinstall the wiper arms.Replacement: windscreen wiper arm – VW JETTA III (1K2). Tip from AUTODOC experts:Make sure not to mix up the wiper arms on the driver's and passenger's sides. - Step 12
Tighten the wiper arm fasteners. Use a drive socket #13. Use a torque wrench. Tighten it to 16 Nm torque. - Step 13
Treat the wiper arm fasteners. Use copper grease. - Step 14
Install the nut covers of the windscreen wiper arms. - Step 15
Remove the cap of the rear wiper arm fastener. - Step 16
Clean the rear wiper arm fastener. Use a wire brush. Use WD-40 spray. - Step 17
Unscrew the rear wiper arm fastener. Use a drive socket #13. Use a ratchet wrench.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Jetta Mk5 (1K) model
Popular maintenance tutorials for VW Jetta 1k2
Complete guides for changing the Wiper arm windscreen washer on different VW JETTA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Jetta Mk5 (1K)
View more
How to Order Car Parts Online: Avoid These 5 Common Pitfalls
CHECK ENGINE light turned on – step-by-step guide on what to do
DIY vehicle AC compressor restoration
Checking the starter without removing it | AUTODOC tips
Most commonly replaced car parts on VW JETTA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




















