When to replace the Wheel Cylinder on your VW PASSAT
Recommended replacement interval for the part category Wheel Brake Cylinder : 60000 km
Important!
This replacement procedure can be used for:
VW PASSAT Variant (33) 1.3, VW PASSAT Variant (33) 1.5, VW PASSAT Variant (33) 1.6, VW PASSAT Variant (33) 1.5 D, VW PASSAT Variant (33) 1.5, VW PASSAT Variant (33) 1.3, VW PASSAT Variant (33) 1.6 D View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Wheel Cylinder for PASSAT Variant (33) and other VW models
Alternative products
How to change Wheel Brake Cylinder on VW Passat Variant Typ 33 1.6 (YN) – step-by-step instructions for straightforward car repair Wheel Brake Cylinder
Tools
Replacement: wheel cylinder – VW PASSAT Variant (33). Tools you'll need:
Wire brush
WD-40 spray
Copper grease
Combination spanner #7
Combination spanner #11
Torx bit T30
Wheel impact socket #17
Ratchet wrench
Torque wrench
Flat Screwdriver
Phillips screwdriver
Wheel chock
Replacement: wheel cylinder – VW PASSAT Variant (33). Tip from AUTODOC:
  • Replace the wheel brake cylinders of the rear drum brakes in pairs.
  • The replacement procedure is identical for the right and left wheel brake cylinders of the rear drum brakes.
  • All work should be done with the engine stopped.
Replacement: wheel cylinder – VW PASSAT Variant (33). Recommended sequence of steps:
  1. Step 1
    How to change Wheel Cylinder on VW Passat Variant Typ 33 1973 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace VW PASSAT Variant (33) 1.6 (YN) 1974 Wheel Cylinder - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    VW Passat Variant Typ 33 1.6 i 1975 Wheel Cylinder replacement: free workshop manuals
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW PASSAT Variant (33)
  4. Step 5
    Changing Wheel Cylinder on VW PASSAT Variant (33) 1.6 1976 by yourself
    Remove the wheel.
  5. Step 6
    Clean the brake drum fasteners. Use a wire brush. Use WD-40 spray.
    Step 7
    How to remove VW PASSAT 1.5 D 1977 Wheel Cylinder - online easy-to-follow instructions
    Unscrew the brake drum fastening. Use a Phillips screwdriver.
  6. Step 8
    How to replace Wheel Cylinder on VW PASSAT Variant (33) 1978: download PDF manuals and video instructions
    Remove the brake drum.
    Replacement: wheel cylinder – VW PASSAT Variant (33). Tip from AUTODOC experts:
    Examine the brake drum. Replace it if necessary.
  7. Step 9
    How hard is it to do yourself: Wheel Cylinder replacement on VW Passat Variant Typ 33 1.6 D 1979 - download illustrated guide
    Disconnect the hydraulic line from the wheel cylinder back. Use a combination spanner #11.
    Replacement: wheel cylinder – VW PASSAT Variant (33). Tip from AUTODOC:
    Immediately plug the brake line open end to prevent fluid leakage and ingress of dirt into the hydraulic system.
  8. Step 10
    Need to know how to renew Wheel Cylinder on VW PASSAT 1980? This free workshop manual will help you to do it yourself
    Unscrew the brake cylinder fastening bolt. Use Torx T30. Use a ratchet wrench.
  9. Step 11
    Changing of Wheel Cylinder on VW Passat Variant Typ 33 1981 won't be an issue if you follow this illustrated step-by-step guide
    Remove the brake cylinder from the backplate. Use a flat screwdriver.
  10. Step 12
    Clean the brake drum. Use a wire brush. Use WD-40 spray.
    Step 13
    Clean the brake pipe attachment spot  and the brake drum fastening bolts on :maker :model.
    Step 14
    VW PASSAT 1.6 i Wheel Cylinder replacement: online guides and video tutorials
    Install a new brake cylinder.
  11. Step 15
    Replacing Wheel Cylinder on VW Passat Variant Typ 33 1974 1.6 (YN) by yourself
    Screw the brake cylinder fastening bolts. Use Torx T30. Use a torque wrench. Tighten it to 8 nm torque.
  12. Step 16
    PASSAT Variant (33) 1.5 D 1975 Wheel Cylinder DIY replacement workshop manual
    Connect the hydraulic line to the wheel cylinder back. Use a combination spanner #11. Use a torque wrench. Tighten it to 14 nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?

Find out which tyre and wheel sizes are compatible with the VW Passat B1 Estate (33) model

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY VW PASSAT Variant (33) Wheel Cylinder replacement - online guide
Tips & tricks for your VW PASSAT Variant (33)
View more
  • How to change Brake wheel cylinder on VW PASSAT Variant (33) 1.3 - replacement tricks
    How to Order Car Parts Online: Avoid These 5 Common Pitfalls
  • Changing Brake cylinder VW Passat Variant Typ 33 1.6 (YN) - Replacement Tips
    The Fast and Easy Way to Fix a Broken Wheel Stud | AUTODOC tips
  • Maintenance Hacks - VW PASSAT Variant (33) 1.6 i Brake wheel cylinder replacement guide
    How to Polish Your Car Yourself and Save Money on Garage Services | AUTODOC tips
  • Replace Brake cylinder on VW Passat Variant Typ 33 - free video tips
    What to do if your check engine light is on | AUTODOC tips
Autodoc CLUB App icon
Time to replace parts? Get even better deals in our Shop app.
VW PASSAT Variant (33) Wheel Cylinder replace by yourself - Scan QR-code and download AUTODOC CLUB app
SCAN ME