Important!

This replacement procedure can be used for:
RENAULT Megane I Box Body / Hatchback (SA0/1_) 1.9 (SA0U, SA0R, SA0A) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Track Rod End for Megane I Box Body / Hatchback (SA0/1_) and other RENAULT models

Tie Rod End

Rod Assembly

Mounting Kit, tie rod end

How to change Tie Rod End on RENAULT Megane I Box Body / Hatchback (SA0/1_) 1.9 (SA0U, SA0R, SA0A) – tips for proper car maintenance

Tie Rod End for RENAULT Megane I Box Body / Hatchback (SA0/1_) 1.9 (SA0U, SA0R, SA0A) Diesel (64 hp)

Replacement: track rod end – RENAULT Megane I Kasten / Schrägheck (SA0/1_). List of the tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Copper grease 
                      
                        Torque wrench
                      
                        Combination spanner #13
                      
                        Combination spanner #19
                      
                        Combination spanner #22
                      
                        Drive socket # 16
                      
                        Drive socket # 17
                      
                        Wheel impact socket #19
                      
                        Ratchet wrench
                      
                        Tap wrench
                      
                        Ball joint puller
                      
                        Vernier caliper
                      
                        Wheel chock

Buy tools

Replacement: track rod end – RENAULT Megane I Kasten / Schrägheck (SA0/1_). Tip from AUTODOC:

Replace tie rod ends in pairs.
The replacement procedure is identical for the right and left tie rod ends.
Please note: all work on the car – RENAULT Megane I Kasten / Schrägheck (SA0/1_) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Secure the wheels with chocks.

Step 2

Loosen the wheel mounting bolts.Use wheel impact socket #19.
Step 3

Raise the car.

Replacement: track rod end – RENAULT Megane I Kasten / Schrägheck (SA0/1_). Tip from AUTODOC:

If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.

Step 4

Unscrew the wheel bolts.

AUTODOC recommends:

Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. RENAULT Megane I Kasten / Schrägheck (SA0/1_)
Step 5

Remove the wheel.
Step 6

Clean all tie rod end connections.Use a wire brush.Use WD-40 spray.
Step 7

When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward.Use a vernier caliper.
Step 8

Loosen the lock nut securing the tie rod end to the tie rod.Use a combination spanner #19.Use a combination spanner #22.
Step 9

Unscrew the end fastening nut to the steering knuckle.Use a drive socket #16.Use a tap wrench.
Step 10

Disconnect the tie rod end from the steering knuckle.Use a ball joint puller.

Step 11

Screw the end out of the tie rod.Use a combination spanner #13.Use a combination spanner #19.
Step 12

Clean the mounting seats of the tie rod end.Use a wire brush.
Step 13

Treat the mounting seats of the tie rod end.Use copper grease.
Step 14

Screw on a new tie rod end.Use a vernier caliper.

Replacement: track rod end – RENAULT Megane I Kasten / Schrägheck (SA0/1_). Tip from AUTODOC:

While installing the steering rod end remember to make the same number of turns or to leave the same length of thread showing as per your measurements.
Step 15

Screw on the tie rod end jam nut. Use a combination spanner #19.Use a combination spanner #22.
Step 16

Connect the tie rod end to the steering knuckle.
Step 17

Screw on the fastening nut that connects the tie rod end to the steering knuckle.Use a drive socket #17.Use a ratchet wrench.
Step 18

Tighten the tie rod end locknut.Use a combination spanner #19.Use a combination spanner #22.Use a torque wrench.Tighten it to 50 nm torque.
Step 19

Tighten the fastening nut connecting the tie rod end to the steering knuckle. Use a drive socket #17.Use a torque wrench.Tighten it to 35 nm torque.
Step 20

Treat the fastener connecting the tie rod end to the steering knuckle. Use copper grease.
Step 21

Clean the wheel rim mounting seat.Use a wire brush.
Step 22

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 23

Clean the brake disk surface.Use a brake cleaner.

AUTODOC recommends:

After applying the spray, wait a few minutes.
Step 24

Install the wheel.

AUTODOC recommends:

Important! Hold the wheel while screwing in the fastening bolts. RENAULT Megane I Kasten / Schrägheck (SA0/1_)
Step 25

Screw in the wheel bolts.Use wheel impact socket #19.
Step 26

Lower the car and working in a cross order, tighten the wheel bolts.Use wheel impact socket #19.Use a torque wrench.Tighten it to 90 Nm torque.
Step 27

Remove the jacks and chocks.

Replacement: track rod end – RENAULT Megane I Kasten / Schrägheck (SA0/1_). AUTODOC experts recommend:

After replacing the component, it is advisable to realign the wheels using a wheel aligner.

Comment

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change front wheel bearing on RENAULT Megane I Box Body / Hatchback (SA0/1_) – replacement guide

Free download PDF

4.31 MB
How to change front brake discs on RENAULT Megane I Box Body / Hatchback (SA0/1_) – replacement guide

Free download PDF

2.61 MB
How to change engine oil and filter on RENAULT Megane I Box Body / Hatchback (SA0/1_) – replacement guide

Free download PDF

1.99 MB
How to change front engine mounts on RENAULT Megane I Box Body / Hatchback (SA0/1_) – replacement guide

Free download PDF

1.99 MB
How to change front brake pads on Renault Clio 2 – replacement guide

Free download PDF

5.8 MB
How to change fuel filter on Renault Clio 3 – replacement guide

Free download PDF

2.61 MB

How to change track rod end on RENAULT Megane I Hatchback (BA) – replacement guide

Free download PDF

1.44 MB
How to change track rod end on RENAULT Megane I Convertible (EA) – replacement guide

Free download PDF

1.44 MB
How to change track rod end on RENAULT Megane I Classic (LA) – replacement guide

Free download PDF

1.44 MB
How to change track rod end on RENAULT Megane I Coach (DA) – replacement guide

Free download PDF

1.44 MB
How to change track rod end on Renault Megane Scenic – replacement guide

Free download PDF

2.2 MB
How to change track rod end on RENAULT Megane I Grandtour (KA) – replacement guide

Free download PDF

1.64 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Tips & tricks for your RENAULT Megane I Box Body / Hatchback (SA0/1_)

What to do if your car's air conditioning isn't working properly | AUTODOC tips

5K views

Published on: 05/08/2021
How to check your head gasket | AUTODOC

3K views

Published on: 03/12/2020
Top 5 mistakes when buying car parts

2K views

Published on: 10/03/2022
What to do if the ABS light comes on | AUTODOC tips

3K views

Published on: 11/03/2021