How to carry out replacement: Wheel Bearing 1.9 TDI Seat Cordoba 6K2
Disclaimer
Change Seat Cordoba 6K2 1.4 16V Wheel Bearing yourself – manuals and video tutorials

How to change rear wheel bearing on SEAT Córdoba I Saloon (6K2) – replacement guide

downloads: 3
Views: 61
Download your free tutorial and fix SEAT Cordoba Saloon (6K2) 1.6 problems yourself Download for free 1.36 MB Wheel Bearing for Seat Cordoba 6K2 Shop now
Leave a comment Open in a new tab
Important!
This replacement procedure can be used for:
SEAT Cordoba Saloon (6K2) 1.4 16V, SEAT Cordoba Saloon (6K2) 1.9 TDI, SEAT Cordoba Saloon (6K2) 1.9 TDI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Wheel Bearing for Cordoba Saloon (6K2) and other SEAT models
Alternative products
How to change Wheel bearing kit on Seat Cordoba 6K2 1.9 TDI – step-by-step instructions for straightforward car repair Wheel bearing kit
Tools
Replacement: wheel bearing – SEAT CORDOBA (6K2). List of the tools you'll need:
Wire brush
WD-40 spray
All-purpose cleaning spray
Copper grease
12-point socket # 30
Wheel impact socket #17
Torque wrench
Tap wrench
Hammer
Rubber mallet
Phillips screwdriver
Crow bar
Wheel chock
Buy tools
Replacement: wheel bearing – SEAT CORDOBA (6K2). AUTODOC recommends:
  • Do not re-use the bearing assembly of your SEAT CORDOBA (6K2) car.
  • The wheel hub bearing replacement procedure is identical for both wheels on the same axle.
  • Please note: all work on the car – SEAT CORDOBA (6K2) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    How to change Wheel Bearing on Seat Cordoba 6K2 1999 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace SEAT Cordoba Saloon (6K2) 1.9 TDI 2000 Wheel Bearing - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    Seat Cordoba 6K2 1.4 2001 Wheel Bearing replacement: free workshop manuals
    Unscrew the wheel bolts.
    Replacement: wheel bearing – SEAT CORDOBA (6K2). Tip:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  4. Step 5
    Changing Wheel Bearing on SEAT Cordoba Saloon (6K2) 1.4 16V 2002 by yourself
    Remove the wheel.
  5. Step 6
    How to remove SEAT CORDOBA 1.0 1999 Wheel Bearing - online easy-to-follow instructions
    Clean the brake drum. Use a wire brush. Use WD-40 spray.
  6. Step 7
    How to replace Wheel Bearing on SEAT Cordoba Saloon (6K2) 2000: download PDF manuals and video instructions
    Unscrew the brake drum fastening. Use a Phillips screwdriver.
  7. Step 8
    How hard is it to do yourself: Wheel Bearing replacement on Seat Cordoba 6K2 1.4 2001 - download illustrated guide
    Remove the brake drum.
    Replacement: wheel bearing – SEAT CORDOBA (6K2). AUTODOC experts recommend:
    Examine the brake drum. Replace it if necessary.
  8. Step 9
    Need to know how to renew Wheel Bearing on SEAT CORDOBA 2002? This free workshop manual will help you to do it yourself
    Remove the hub bearing protection cap. Use a hammer. Use a crowbar.
    Replacement: wheel bearing – SEAT CORDOBA (6K2). Tip from AUTODOC:
    Some cars are not equipped with wheel hub caps.
  9. Step 10
    Changing of Wheel Bearing on Seat Cordoba 6K2 1999 won't be an issue if you follow this illustrated step-by-step guide
    Unscrew the wheel hub axle nut. Use drive 12-point socket #30. Use a tap wrench.
  10. Step 11
    SEAT CORDOBA 1.4 16V Wheel Bearing replacement: online guides and video tutorials
    Remove the hub and the bearing together, since they are a sealed unit.
  11. Step 12
    Replacing Wheel Bearing on Seat Cordoba 6K2 2001 1.9 TDI by yourself
    Clean the hub bearing mounting seat. Use all-purpose cleaning spray.
  12. Step 13
    Cordoba Saloon (6K2) 1.0 2002 Wheel Bearing DIY replacement workshop manual
    Install the new wheel hub with a bearing.
  13. Step 14
    How to change Wheel Bearing on SEAT Cordoba Saloon (6K2) 1999 - tips and tricks
    Tighten the hub. Use drive 12-point socket #30. Use a torque wrench. Tighten it to 175 nm torque.
    Replacement: wheel bearing – SEAT CORDOBA (6K2). Professionals recommend:
    The wheel bearing unit must not tilt on the axle pin.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?

Find out which tyre and wheel sizes are compatible with the SEAT Córdoba I Saloon (6K2) model

Seat Cordoba 6K2 tyre size

Popular maintenance tutorials for Seat Cordoba 6K2

More manuals for Seat Cordoba 6K2

Complete guides for changing the Wheel bearings on different SEAT CORDOBA models

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY SEAT Cordoba Saloon (6K2) Wheel Bearing replacement - online guide
Tips & tricks for your SEAT Cordoba Saloon (6K2)
View more
  • How to change Wheel bearings on SEAT Cordoba Saloon (6K2) 1.6 - replacement tricks
    5 most common causes of oil leaks | AUTODOC tips
    59K views
    Published on: 30/03/2023
  • Changing Hub bearing Seat Cordoba 6K2 1.9 TDI - Replacement Tips
    How to unlock your car without a key | AUTODOC tips
    1M views
    Published on: 15/09/2022
  • Maintenance Hacks - SEAT Cordoba Saloon (6K2) 1.4 Wheel bearing kit replacement guide
    Top 5 reasons why the suspension knocks | AUTODOC tips
    2M views
    Published on: 09/09/2022
  • Replace Wheel hub bearing on Seat Cordoba 6K2 - free video tips
    Initial Car Inspection: What to Check Before You Buy
    5K views
    Published on: 24/10/2020

Most commonly replaced car parts on SEAT CORDOBA

Professional manuals for the most common SEAT models

Autodoc CLUB App icon
Time to replace parts? Get even better deals in our Shop app.
SEAT Cordoba Saloon (6K2) Wheel Bearing replace by yourself - Scan QR-code and download AUTODOC CLUB app
SCAN ME