Important!
This replacement procedure can be used for:
VW Polo Variant (6V5) 1.4, VW Polo Variant (6V5) 1.6, VW Polo Variant (6V5) 1.6, VW Polo Variant (6V5) 1.9 TDI, VW Polo Variant (6V5) 1.7 SDI, VW Polo Variant (6V5) 1.9 SDI, VW Polo Variant (6V5) 1.9 TDI, VW Polo Variant (6V5) 1.4 16V, VW Polo Variant (6V5) 1.9 SDI View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Strut Mount for Polo Variant (6V5) and other VW models
Alternative products
How to change Supporting Ring, suspension strut bearing on VW Polo Variant 1.4 – step-by-step instructions for straightforward car repair Supporting Ring, suspension strut bearing
Tools
Replacement: strut mount – VW POLO Variant (6KV5). Tools you'll need:
Wire brush
WD-40 spray
Copper grease
Torque wrench
Combination spanner #17
Drive socket # 10
Drive socket # 17
Wheel impact socket #17
Ratchet wrench
Tap wrench
Shock absorber socket #DD5,2
Hydraulic strut spring compressor
Hydraulic transmission jack
Wheel chock
Replacement: strut mount – VW POLO Variant (6KV5). Professionals recommend:
  • The replacement procedure is identical for the mounts of the left and right shock struts of the rear suspension.
  • All mounts of the rear shock struts should be replaced simultaneously.
  • All work should be done with the engine stopped.
Replacement: strut mount – VW POLO Variant (6KV5). Take the following steps:
  1. Step 1
    Open the boot lid.
    Step 2
    Move the folding shelf and detach it from the retainers. By doing this, you will get access to the side trim plastic panels.
    Step 3
    How to change Strut Mount on VW Polo Variant 1997 - free PDF and video manuals
    Unscrew the fasteners of the side plastic trim panel. Use a drive socket #10. Use a ratchet wrench.
  2. Step 4
    How to replace VW Polo Variant (6V5) 1.4 1998 Strut Mount - step-by-step manuals and video guides
    Remove the side plastic cover.
  3. Step 5
    VW Polo Variant 1.6 1999 Strut Mount replacement: free workshop manuals
    Clean the fasteners of the shock strut upper mount. Use a wire brush. Use WD-40 spray.
  4. Step 6
    Changing Strut Mount on VW Polo Variant (6V5) 1.9 SDI 2000 by yourself
    Loosen the upper fastener of the shock strut mount. Use a combination spanner #17. Use a shock absorber socket #DD5,2. Use a ratchet wrench.
  5. Step 7
    How to remove VW POLO 1.4 16V 2001 Strut Mount - online easy-to-follow instructions
    Secure the wheels with chocks.
  6. Step 8
    How to replace Strut Mount on VW Polo Variant (6V5) 1997: download PDF manuals and video instructions
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  7. Step 9
    Raise the rear of the car and secure on supports.
    Step 10
    How hard is it to do yourself: Strut Mount replacement on VW Polo Variant 1.4 1998 - download illustrated guide
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW POLO Variant (6KV5)
  8. Step 11
    Need to know how to renew Strut Mount on VW POLO 1999? This free workshop manual will help you to do it yourself
    Remove the wheel.
  9. Step 12
    Changing of Strut Mount on VW Polo Variant 2000 won't be an issue if you follow this illustrated step-by-step guide
    Clean the shock strut fasteners. Use a wire brush. Use WD-40 spray.
  10. Step 13
    VW POLO 1.9 TDI Strut Mount replacement: online guides and video tutorials
    Support the rear suspension beam. Use a hydraulic transmission jack.
  11. Step 14
    Replacing Strut Mount on VW Polo Variant 1997 1.4 by yourself
    Unscrew the lower fastener of the shock absorber strut. Use a combination spanner #17. Use a drive socket #17. Use a tap wrench.
  12. Step 15
    Polo Variant (6V5) 1.4 16V 1998 Strut Mount DIY replacement workshop manual
    Unscrew the top fastening of the shock strut mount.
    AUTODOC recommends:
    To avoid injuries, hold the shock strut when undoing the fastening bolts.
  13. Step 16
    How to change Strut Mount on VW Polo Variant (6V5) 1999 - tips and tricks
    Remove the mounting from under the rear axle beam.
    Replacement: strut mount – VW POLO Variant (6KV5). Tip:
    Lower the hydraulic transmission jack smoothly, without jerks, to avoid damaging assemblies and mechanisms.
  14. Step 17
    Step-by-step recommendations for DIY replacement VW Polo Variant 2000 1.4 16V Strut Mount
    Remove the fastening bolt.
  15. Step 18
    DIY replacement of Strut Mount on VW Polo Variant (6V5) 1.9 TDI 2001 is not an issue anymore with our step-by-step tutorial
    Remove the suspension strut.
  16. Step 19
    Set the shock absorber strut on the spring compressor tool.
    AUTODOC recommends:
    Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles.
    Step 20
    How to change Strut Mount on VW Polo Variant 1997 - free PDF and video manuals
    Remove the top strut mount.
    Replacement: strut mount – VW POLO Variant (6KV5). AUTODOC recommends:
    Examine the shock absorber dust cap and the bump stop. Replace them if necessary.
  17. Step 21
    How to replace VW Polo Variant (6V5) 1.4 1998 Strut Mount - step-by-step manuals and video guides
    Treat the shock strut rod. Use a wire brush. Use WD-40 spray. Use copper grease.
  18. Step 22
    VW Polo Variant 1.6 1999 Strut Mount replacement: free workshop manuals
    Install a new strut mount.
  19. Step 23
    Remove the assembled shock strut.
    Step 24
    Changing Strut Mount on VW Polo Variant (6V5) 1.9 SDI 2000 by yourself
    Treat the mounting seats of the shock strut. Use a wire brush. Use WD-40 spray.
  20. Step 25
    How to remove VW POLO 1.4 16V 2001 Strut Mount - online easy-to-follow instructions
    Install the shock strut into the wheel arch.
  21. Step 26
    How to replace Strut Mount on VW Polo Variant (6V5) 1997: download PDF manuals and video instructions
    Support the rear suspension beam. Use a hydraulic transmission jack.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?

Find out which tyre and wheel sizes are compatible with the VW Polo III Variant (6V5) model

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY VW Polo Variant (6V5) Strut Mount replacement - online guide
Tips & tricks for your VW Polo Variant (6V5)
View more
  • How to change Strut mount on VW Polo Variant (6V5) 1.9 TDI - replacement tricks
    #DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
  • Changing Top mount VW Polo Variant 1.4 - Replacement Tips
    Petrol or diesel: The engine showdown! | AUTODOC
  • Maintenance Hacks - VW Polo Variant (6V5) 1.6 Top strut mount replacement guide
    Motorcycle fuel tank restoration
  • Replace Top mounts on VW Polo Variant - free video tips
    Unveiling the secrets: Detecting vacuum leaks with a Smoke Machine | AUTODOC
Autodoc CLUB App icon
Time to replace parts? Get even better deals in our Shop app.
VW Polo Variant (6V5) Strut Mount replace by yourself - Scan QR-code and download AUTODOC CLUB app
SCAN ME