
Disclaimer
How to change rear shock absorbers on VW PASSAT (3B2) – replacement guide
downloads:
0
Views:
13
Important!
This replacement procedure can be used for:
VW PASSAT (3B2) 1.6, VW PASSAT (3B2) 1.8, VW PASSAT (3B2) 1.8 T, VW PASSAT (3B2) 2.3 VR5, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 2.8 V6, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 2.5 TDI, VW PASSAT (3B2) 2.0, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 1.8, VW PASSAT (3B2) 2.8 V6, VW PASSAT (3B2) 2.8 V6 … View more
The steps may slightly vary depending on the car design.
VW PASSAT (3B2) 1.6, VW PASSAT (3B2) 1.8, VW PASSAT (3B2) 1.8 T, VW PASSAT (3B2) 2.3 VR5, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 2.8 V6, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 2.5 TDI, VW PASSAT (3B2) 2.0, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 1.8, VW PASSAT (3B2) 2.8 V6, VW PASSAT (3B2) 2.8 V6 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Shock Absorber for PASSAT (3B2) and other VW models
Shock absorber
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Drive socket # 13
Drive socket # 16
Drive socket # 17
Combination spanner #16
Wheel impact socket #17
Ratchet wrench
Torque wrench
Locking pliers
Shock absorber socket №5
Vice
Hydraulic transmission jack
Wheel chock
Replacement: shock absorbers – VW PASSAT (3B2). Tip from AUTODOC experts:
- Both shock absorbers of the rear suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right shock absorbers of the rear suspension.
- Please note: all work on the car – VW PASSAT (3B2) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Secure the wheels with chocks.
- Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the rear of the car and secure on supports.Step 4Unscrew the wheel bolts.Replacement: shock absorbers – VW PASSAT (3B2). Tip:To avoid injury, hold up the wheel when unscrewing the bolts.
- Step 5Remove the wheel.
- Step 6Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
- Step 7Support the rear suspension beam. Use a hydraulic transmission jack.
- Step 8Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
- Step 9Remove the fastening bolt.
- Step 10Remove the mounting from under the rear axle beam.AUTODOC recommends:Replacement: shock absorbers – VW PASSAT (3B2). Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
- Step 11Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
- Step 12Unscrew the upper fastener of the shock absorber. Use a drive socket #13. Use a ratchet wrench.Replacement: shock absorbers – VW PASSAT (3B2). Professionals recommend:To avoid injuries, hold the shock absorber when undoing the fastening bolts.
- Step 13Remove the shock absorber.
- Step 14Grip the shock absorber in a vice.
- Step 15Clean the shock absorber rod fastener. Use a wire brush. Use WD-40 spray.
- Step 16Remove the shock absorber piston rod fastening. Use a shock absorber socket #5. Use a drive socket #17. Use a ratchet wrench.
- Step 17Remove the shock absorber mount, boot and bump stop.Replacement: shock absorbers – VW PASSAT (3B2). Tip from AUTODOC experts:Examine the shock absorber dust cap and the bump stop. Replace them if necessary.
- Step 18Install the mount, boot and bump stop onto a new shock absorber.
- Step 19Screw the shock strut piston rod upper fastening. Use a combination spanner #17. Use locking pliers. Use a torque wrench. Tighten it to 25 Nm torque.
- Step 20Release the vice and take out the shock absorber.Replacement: shock absorbers – VW PASSAT (3B2). AUTODOC recommends:Before installing a new shock absorber you should pump it manually 3-5 times.
- Step 21Clean the shock absorber mounting seats. Use a wire brush. Use WD-40 spray.
- Step 22Place the shock absorber in the wheel arch and secure it.AUTODOC recommends:Important! Hold the shock absorber while screwing in the fastening bolts. VW PASSAT (3B2)
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Passat B5 Saloon (3B2) model
Popular maintenance tutorials for Passat 3b2
Complete guides for changing the Shock absorbers on different VW PASSAT models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW PASSAT (3B2)
View more
- Reviving Your Car: How to Start After Extended Idle Time | AUTODOC Tips
- How to Get the Best Deals on Car Parts | Save Money with AUTODOC
- How to Install a New Windscreen Yourself | AUTODOC Expert Tips
- Top 5 mistakes when replacing spark plugs | AUTODOC tips
Most commonly replaced car parts on VW PASSAT
Time to replace parts? Get even better deals in our Shop app.

SCAN ME