
Disclaimer
How to change rear shock absorbers on VW Passat CC (357) – replacement guide
downloads:
7
Views:
305
Important!
This replacement procedure can be used for:
VW Passat CC (357) 2.0 TSI, VW Passat CC (357) 1.8 TSI, VW Passat CC (357) 2.0 TDI, VW Passat CC (357) 1.4 TSI MultiFuel, VW Passat CC (357) 3.6 FSI 4motion, VW Passat CC (357) 3.6 FSI, VW Passat CC (357) 1.8 TSI, VW Passat CC (357) 3.6 FSI 4motion, VW Passat CC (357) 2.0 TDI, VW Passat CC (357) 2.0 TDI, VW Passat CC (357) 2.0 TFSI, VW Passat CC (357) 2.0 TDI, VW Passat CC (357) 2.0 BlueTDI, VW Passat CC (357) 2.0 TDI 4motion, VW Passat CC (357) 2.0 TDI 4motion … View more
The steps may slightly vary depending on the car design.
VW Passat CC (357) 2.0 TSI, VW Passat CC (357) 1.8 TSI, VW Passat CC (357) 2.0 TDI, VW Passat CC (357) 1.4 TSI MultiFuel, VW Passat CC (357) 3.6 FSI 4motion, VW Passat CC (357) 3.6 FSI, VW Passat CC (357) 1.8 TSI, VW Passat CC (357) 3.6 FSI 4motion, VW Passat CC (357) 2.0 TDI, VW Passat CC (357) 2.0 TDI, VW Passat CC (357) 2.0 TFSI, VW Passat CC (357) 2.0 TDI, VW Passat CC (357) 2.0 BlueTDI, VW Passat CC (357) 2.0 TDI 4motion, VW Passat CC (357) 2.0 TDI 4motion … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Shock Absorber for Passat CC (357) and other VW models
Shock absorber
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Torque wrench
Combination spanner #18
Combination spanner #21
Drive socket # 16
Drive socket # 17
Drive socket # 18
Drive socket # 21
Torx bit T25
Shock absorber socket #DD5,2
Wheel impact socket #17
Ratchet wrench
Vice
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: shock absorbers – VW PASSAT CC (357). AUTODOC recommends:
- Both shock absorbers of the rear suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right shock absorbers of the rear suspension.
- Please note: all work on the car – VW PASSAT CC (357) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Secure the wheels with chocks.Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the rear of the car and secure on supports.Step 4Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW PASSAT CC (357)
- Step 5Remove the wheel.
- Step 6Support the arm. Use a hydraulic transmission jack.
- Step 7Clean the fasteners of the locker. Use a wire brush. Use WD-40 spray.
- Step 8Unscrew and remove the wheel arch cover fasteners. Use Torx T25.
- Step 9Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
- Step 10Unscrew the lower fastener of the shock absorber. Use a combination spanner #21.
- Step 11Clean the control arm fasteners. Use a wire brush. Use WD-40 spray.
- Step 12Unscrew the lower arm fastener. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench.
- Step 13Remove the fastening bolt.
- Step 14Lower the hydraulic transmission jack by 10-15 cm.Step 15Remove the fastening bolt.
- Step 16Unscrew the upper fastener of the shock absorber. Use a drive socket #16. Use a ratchet wrench.AUTODOC recommends:Important! Hold the shock absorber while unscrewing the fastening bolts. VW PASSAT CC (357)
- Step 17Remove the shock absorber.
- Step 18Clean the shock absorber mounting seats. Use a wire brush. Use WD-40 spray.
- Step 19Grip the shock absorber in a vice.
- Step 20Remove the protective cap of the shock absorber mount. Use a crowbar.
- Step 21Clean the shock absorber rod fastener. Use a wire brush. Use WD-40 spray.
- Step 22Remove the shock absorber piston rod fastening. Use a drive socket #17. Use a shock absorber socket DD#5,2. Use a ratchet wrench.
- Step 23Remove the shock absorber mount, boot and bump stop.AUTODOC recommends:Replacement: shock absorbers – VW PASSAT CC (357). Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.Before installing a new shock absorber you should pump it manually 3-5 times.
- Step 24Install the mount, boot and bump stop onto a new shock absorber.
- Step 25Screw the shock strut piston rod upper fastening. Use a drive socket #17. Use a shock absorber socket DD#5,2. Use a torque wrench. Tighten it to 25 Nm torque.
- Step 26Treat the shock absorber rod fastener. Use copper grease.
- Step 27Install the protective shock absorber mounting cap.
- Step 28Release the vice and take out the shock absorber.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Passat CC (357) model
Popular maintenance tutorials for VW Passat CC
Complete guides for changing the Shock absorbers on different VW PASSAT models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Passat CC (357)
View more
- Drive with Care: 8 Common Bad Driving Habits Explained | AUTODOC
- Why Is the Windscreen Washer Not Spraying? Solution
- How to replace a timing chain yourself
- Easy Steps to Paint Brake Calipers Without Special Skills or High Costs
Most commonly replaced car parts on VW PASSAT
Time to replace parts? Get even better deals in our Shop app.

SCAN ME