
Disclaimer
How to change rear coil springs on VW Polo 9N – replacement guide
downloads:
6
Views:
94
Important!
This replacement procedure can be used for:
VW POLO (9N_) 1.4 16V, VW POLO (9N_) 1.9 TDI, VW POLO (9N_) 1.4 TDI, VW POLO (9N_) 1.4 16V, VW POLO (9N_) 1.2 12V, VW POLO (9N_) 1.9 SDI, VW POLO (9N_) 1.2, VW POLO (9N_) 1.4 16V, VW POLO (9N_) 1.4 FSI, VW POLO (9N_) 1.9 TDI, VW POLO (9N_) 1.4 TDI, VW POLO (9N_) 1.4 TDI, VW POLO (9N_) 1.2, VW POLO (9N_) 1.2 12V, VW POLO (9N_) 1.4 … View more
The steps may slightly vary depending on the car design.
VW POLO (9N_) 1.4 16V, VW POLO (9N_) 1.9 TDI, VW POLO (9N_) 1.4 TDI, VW POLO (9N_) 1.4 16V, VW POLO (9N_) 1.2 12V, VW POLO (9N_) 1.9 SDI, VW POLO (9N_) 1.2, VW POLO (9N_) 1.4 16V, VW POLO (9N_) 1.4 FSI, VW POLO (9N_) 1.9 TDI, VW POLO (9N_) 1.4 TDI, VW POLO (9N_) 1.4 TDI, VW POLO (9N_) 1.2, VW POLO (9N_) 1.2 12V, VW POLO (9N_) 1.4 … View more
The steps may slightly vary depending on the car design.
How to change rear springs / rear coil springs on VW POLO 4 (9N) [TUTORIAL AUTODOC]

All the parts you need to replace – Springs for POLO (9N_) and other VW models
Coil spring
Alternative products

Wire brush
WD-40 spray
Copper grease
Drive socket # 16
Combination spanner #16
Wheel impact socket #17
Ratchet wrench
Torque wrench
Hydraulic transmission jack
Wheel chock
Replacement: coil springs – VW Polo 9N. Tip from AUTODOC:
- Both coil springs of the rear suspension should be replaced simultaneously.
- The replacement procedure is identical for the left and right coil springs of the rear suspension.
- Please note: all work on the car – VW Polo 9N – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Secure the wheels with chocks.
- Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the rear of the car and secure on supports.
- Step 4Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW Polo 9N
- Step 5Remove the wheel.
- Step 6Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
- Step 7Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
- Step 8Support the rear suspension beam. Use a hydraulic transmission jack.
- Step 9Remove the fastening bolt.
- Step 10Remove the mounting from under the rear axle beam.AUTODOC recommends:Replacement: coil springs – VW Polo 9N. Lower the transmission jack smoothly, without jerks, to avoid damaging components and mechanisms.
- Step 11Take out the spring.Replacement: coil springs – VW Polo 9N. Tip from AUTODOC:Inspect the rubber mounts of the suspension spring. Replace if necessary.
- Step 12Clean the coil spring mounting seats. Use a wire brush. Use WD-40 spray.
- Step 13Install the coil spring together with the rubber mounts into the mounting seats.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Polo IV Hatchback (9N) model
Popular maintenance tutorials for VW Polo Mk4
Complete guides for changing the Springs on different VW POLO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW POLO (9N_)
View more
- Don’t Replace, Just Polish! Headlight Restoration with AUTODOC
- Fuse Replacement Made Simple: Step-by-Step Guide | AUTODOC
- DIY jack restoration | AUTODOC tips
- Stop Rust Before It Starts: Top 5 Tips for Car Body Protection | AUTODOC Insights
Most commonly replaced car parts on VW POLO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME