
Disclaimer
How to change rear brake pads on VW Passat Variant (365) – replacement guide
downloads:
5
Views:
59

Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
VW Passat Variant (365) 1.4 TSI, VW Passat Variant (365) 1.8 TSI, VW Passat Variant (365) 1.6 TDI, VW Passat Variant (365) 2.0 TSI, VW Passat Variant (365) 2.0 TDI, VW Passat Variant (365) 2.0 TDI 4motion, VW Passat Variant (365) 2.0 TDI, VW Passat Variant (365) 2.0 TDI 4motion, VW Passat Variant (365) 1.4 TSI EcoFuel, VW Passat Variant (365) 3.6 FSI 4motion, VW Passat Variant (365) 1.4 TSI MultiFuel, VW Passat Variant (365) 2.0 TDI, VW Passat Variant (365) 1.8 TSI, VW Passat Variant (365) 2.0 TDI, VW Passat Variant (365) 1.4 TSI, VW Passat Variant (365) 2.0 TDI 4motion … View more
The steps may slightly vary depending on the car design.
VW Passat Variant (365) 1.4 TSI, VW Passat Variant (365) 1.8 TSI, VW Passat Variant (365) 1.6 TDI, VW Passat Variant (365) 2.0 TSI, VW Passat Variant (365) 2.0 TDI, VW Passat Variant (365) 2.0 TDI 4motion, VW Passat Variant (365) 2.0 TDI, VW Passat Variant (365) 2.0 TDI 4motion, VW Passat Variant (365) 1.4 TSI EcoFuel, VW Passat Variant (365) 3.6 FSI 4motion, VW Passat Variant (365) 1.4 TSI MultiFuel, VW Passat Variant (365) 2.0 TDI, VW Passat Variant (365) 1.8 TSI, VW Passat Variant (365) 2.0 TDI, VW Passat Variant (365) 1.4 TSI, VW Passat Variant (365) 2.0 TDI 4motion … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for Passat Variant (365) and other VW models
Brake pad set
Alternative products

Wire brush
WD-40 spray
Nylon cleaning brush
Brake cleaner
Anti-squeal paste
Copper grease
Torque wrench
Combination spanner #13
Combination spanner #15
Drive socket # 13
Torx bit T27
Wheel impact socket #17
Ratchet wrench
Brake caliper wind back tool
Crow bar
Wheel chock
Replacement: brake pads – VW PASSAT Variant (365). Tip from AUTODOC experts:
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- Please note: all work on the car – VW PASSAT Variant (365) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Connect the scan and service tool.
- Step 2Put the parking brake system into service mode.Step 3Open the hood.Step 4Clean the brake fluid reservoir cap. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – VW PASSAT Variant (365). After applying the spray, wait a few minutes.Step 5Unscrew the engine solenoid valve bracket. Use Torx T27. Use a ratchet wrench.
- Step 6Unscrew the brake fluid reservoir cap.
- Step 7Secure the wheels with chocks.Step 8Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 9Raise the rear of the car and secure on supports.Step 10Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW PASSAT Variant (365)
- Step 11Remove the wheel.
- Step 12Spread the brake pads. Use a crowbar.
- Step 13Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
- Step 14Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #15. Use a drive socket #13. Use a ratchet wrench.
- Step 15Remove the brake caliper.Replacement: brake pads – VW PASSAT Variant (365). Tip from AUTODOC experts:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
- Step 16Remove the brake pads.Replacement: brake pads – VW PASSAT Variant (365). AUTODOC experts recommend:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
- Step 17Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – VW PASSAT Variant (365). After applying the spray, wait a few minutes.
- Step 18Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.Replacement: brake pads – VW PASSAT Variant (365). Tip:Make sure the disc surface is clean before installing the pads.
- Step 19Install new brake pads.Replacement: brake pads – VW PASSAT Variant (365). Tip from AUTODOC experts:Make sure the pads are installed with linings facing the disc.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Passat B7 Variant (365) model
Popular maintenance tutorials for Passat 365
Complete guides for changing the Brake pad set on different VW PASSAT models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Passat Variant (365)
View more
- Transform Your Engine Bay: Affordable Valve Cover Restoration with AUTODOC
- TOP 8 mistakes car owners make | AUTODOC tips
- How to get your motorcycle ready for spring
- Initial Car Inspection: What to Check Before You Buy
Most commonly replaced car parts on VW PASSAT
Time to replace parts? Get even better deals in our Shop app.

SCAN ME