When to replace the Brake Pads on your VW GOLF
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
VW GOLF III (1H1) 1.9 TDI, VW GOLF III (1H1) 1.6, VW GOLF III (1H1) 2.9 VR6 Syncro (1HX1), VW GOLF III (1H1) 2.8 VR6, VW GOLF III (1H1) 2.0 GTI 16V, VW GOLF III (1H1) 2.0 View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Tools
Replacement: brake pads – VW GOLF III (1H1). List of the tools you'll need:
Wire brush
Nylon cleaning brush
WD-40 spray
Brake cleaner
Anti-squeal paste
Ceramic grease
Torque wrench
Combination spanner #13
Combination spanner #15
Drive socket # 13
Wheel impact socket #17
Brake caliper wind back tool
Crow bar
Wheel chock
Replacement: brake pads – VW GOLF III (1H1). Tip from AUTODOC:
  • Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
  • The replacement procedure is identical for all brake pads on the same axle.
  • Please note: all work on the car – VW GOLF III (1H1) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    Open the bonnet. Unscrew the brake fluid reservoir cap.
    Step 2
    Secure the wheels with chocks.
    Step 3
    How to change Brake Pads on Golf 3 1991 - free PDF and video manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  2. Step 4
    Raise the car.
    Replacement: brake pads – VW GOLF III (1H1). Tip:
    If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.
    Step 5
    How to replace VW GOLF III (1H1) 2.8 VR6 1992 Brake Pads - step-by-step manuals and video guides
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW GOLF III (1H1)
  3. Step 6
    Golf 3 2.0 1993 Brake Pads replacement: free workshop manuals
    Remove the wheel.
  4. Step 7
    Changing Brake Pads on VW GOLF III (1H1) 1.9 TDI 1994 by yourself
    Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
  5. Step 8
    How to remove VW GOLF 1.6 1995 Brake Pads - online easy-to-follow instructions
    Unscrew the brake caliper fasteners. Use a combination spanner #13. Use a combination spanner #15.
  6. Step 9
    How to replace Brake Pads on VW GOLF III (1H1) 1996: download PDF manuals and video instructions
    Remove the brake caliper. Use a crowbar.
    Replacement: brake pads – VW GOLF III (1H1). Tip from AUTODOC experts:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
  7. Step 10
    How hard is it to do yourself: Brake Pads replacement on Golf 3 2.0 GTI 16V 1997 - download illustrated guide
    Remove the brake pads.
    AUTODOC recommends:
    Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
  8. Step 11
    Need to know how to renew Brake Pads on VW GOLF 1998? This free workshop manual will help you to do it yourself
    Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.
    AUTODOC recommends:
    After applying the spray, wait a few minutes.
  9. Step 12
    Changing of Brake Pads on Golf 3 1991 won't be an issue if you follow this illustrated step-by-step guide
    Press in the brake caliper piston. Use brake caliper wind back tool.
  10. Step 13
    VW GOLF 2.8 VR6 Brake Pads replacement: online guides and video tutorials
    Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.
    AUTODOC recommends:
    Replacement: brake pads – VW GOLF III (1H1). After applying the spray, wait a few minutes.Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
  11. Step 14
    Replacing Brake Pads on Golf 3 1993 2.8 VR6 by yourself
    Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.
    Replacement: brake pads – VW GOLF III (1H1). Tip from AUTODOC:
    Make sure the disc surface is clean before installing the pads.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VW Golf III Hatchback (1H1) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
VW GOLF III (1H1) Brake Pads replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY VW GOLF III (1H1) Brake Pads replacement - online guide
Tips & tricks for your VW GOLF III (1H1)
View more
  • How to change Brake pad set on VW GOLF III (1H1) 1.8 - replacement tricks
    How to swap the engine on a BMW E30 Turbo | SUPERCAR AUTODOC
  • Changing Disc pads Golf 3 2.8 VR6 - Replacement Tips
    Headlight Restoration | AUTODOC tips
  • Maintenance Hacks - VW GOLF III (1H1) 2.0 Brake pad kit replacement guide
    TOP 5 mistakes during DIY oil change | AUTODOC tips
  • Replace Disc brake pads on Golf 3 - free video tips
    Replacing your engine cooling fan | AUTODOC tips