Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
CITROËN BERLINGO (B9) 1.6 HDi 90, CITROËN BERLINGO (B9) 1.6, CITROËN BERLINGO (B9) 1.6, CITROËN BERLINGO (B9) 1.6 HDi 75 16V, CITROËN BERLINGO (B9) 1.6 HDi 90, CITROËN BERLINGO (B9) 1.6 HDi 110, CITROËN BERLINGO (B9) 1.6 VTi 120, CITROËN BERLINGO (B9) 1.6 VTi 95, CITROËN BERLINGO (B9) 1.6 HDi 110, CITROËN BERLINGO (B9) 1.6 HDi 115, CITROËN BERLINGO (B9) 1.6 BlueHDi 100, CITROËN BERLINGO (B9) 1.6 BlueHDi 120, CITROËN BERLINGO (B9) 1.6 HDi 75 / BlueHDi 75, CITROËN BERLINGO (B9) 1.2 PureTech 110 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for BERLINGO (B9) and other CITROËN models

Brake pad set

        Brake pad set for Berlingo II (B9) Diesel (92 hp)
      
        Brake pad set for Berlingo II (B9) Petrol (90 hp)
      
        Brake pad set for Berlingo II (B9) Petrol (109 hp)
      
        Brake pad set for Berlingo II (B9) Diesel (75 hp)
      
        Brake pad set for Berlingo II (B9) Diesel (90 hp)
      
        Brake pad set for Berlingo II (B9) Diesel (109 hp)
      
        Brake pad set for Berlingo II (B9) Petrol (120 hp)
      
        Brake pad set for Berlingo II (B9) Petrol (98 hp)
      
        Brake pad set for Berlingo II (B9) Diesel (112 hp)

Replacement: brake pads – CITROËN BERLINGO (B9). Tools you need:

                        Wire brush
                      
                        Nylon cleaning brush
                      
                        WD-40 spray
                      
                        All-purpose cleaning spray
                      
                        Brake cleaner 
                      
                        Anti-squeal paste
                      
                        Copper grease 
                      
                        Torque wrench
                      
                        Combination spanner #19
                      
                        Drive socket # 13
                      
                        Wheel impact socket #17
                      
                        Ratchet wrench
                      
                        Brake caliper wind back tool
                      
                        Pliers 
                      
                        Water pump pliers
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

Replacement: brake pads – CITROËN BERLINGO (B9). AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
Warning! Shut down the engine before starting any work – CITROËN BERLINGO (B9).

Carry out replacement in the following order:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.

Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – CITROËN BERLINGO (B9). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Clean the fastener of the parking brake cable. Use a wire brush. Use WD-40 spray.
Step 8

Release the parking brake cable. Use water pump pliers. Use pliers. Use a crowbar.
Step 9

Clean the brake caliper fasteners. Use a wire brush. Use all-purpose cleaning spray.
Step 10

Unscrew the brake caliper fastening. Use a combination spanner #19. Use a drive socket #13. Use a ratchet wrench.
Step 11

Spread the brake pads. Use a crowbar.
Step 12

Remove the brake caliper.

Replacement: brake pads – CITROËN BERLINGO (B9). Professionals recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 13

Remove the brake pads. Use a crowbar.

AUTODOC recommends:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 14

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 15

Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.

Replacement: brake pads – CITROËN BERLINGO (B9). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 16

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 17

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 18

Install new brake pads.

Replacement: brake pads – CITROËN BERLINGO (B9). AUTODOC experts recommend:
Make sure the pads are installed with linings facing the disc.
Step 19

Install the brake caliper and fix it. Use a combination spanner #19. Use a drive socket #13. Use a torque wrench. Tighten it to 30 Nm torque.
Step 20

Install the parking brake cable into the brake caliper bracket. Use water pump pliers. Use pliers.
Step 21

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 22

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 23

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. CITROËN BERLINGO (B9)
Step 24

Screw in the wheel bolts. Use wheel impact socket #17.
Step 25

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 100 Nm torque.
Step 26

Remove the jacks and chocks.

AUTODOC recommends:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 27

Tighten the brake fluid reservoir cap.

Step 28

Close the hood.

Replacement: brake pads – CITROËN BERLINGO (B9). AUTODOC experts recommend:
Without starting the engine, press the brake pedal several times until you feel significant resistance.Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the CITROËN Berlingo II (B9) model.

Browse tyres

How to change front brake discs on CITROËN BERLINGO (B9) – replacement guide

Free download PDF
2 MB
How to change brake drum on CITROËN Berlingo II (B9) – replacement guide

Free download PDF
2.25 MB
How to change rear wheel bearing on CITROËN BERLINGO (B9) – replacement guide

Free download PDF
1.52 MB
How to change front wheel bearing on CITROËN BERLINGO (B9) – replacement guide

Free download PDF
5.01 MB
How to change serpentine belt on CITROËN BERLINGO (B9) – replacement guide

Free download PDF
634.88 KB
How to change spark plugs on CITROËN BERLINGO (B9) – replacement guide

Free download PDF
1.16 MB

How to change rear brake pads on CITROËN BERLINGO Box (B9) – replacement guide

Free download PDF
1.59 MB
How to change front brake pads on CITROËN BERLINGO Box (B9) – replacement guide

Free download PDF
1.46 MB
How to change front brake pads on Citroën Berlingo M – replacement guide

Free download PDF
1.47 MB
How to change rear brake pads on CITROËN Berlingo / Berlingo First Van (M_) – replacement guide

Free download PDF
1.59 MB
How to change front brake pads on CITROËN Berlingo / Berlingo First (MF, GJK, GFK) – replacement guide

Free download PDF
1.29 MB
How to change rear brake pads on CITROËN Berlingo / Berlingo First (MF, GJK, GFK) – replacement guide

Free download PDF
1.59 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

DIY starter repair | AUTODOC tips

40K views

Published on: 31/08/2023
What causes engine misfire? | AUTODOC

5K views

Published on: 10/07/2020
How to paint a brake caliper | AUTODOC tips

10K views

Published on: 08/04/2021
Top 6 products for enhancing your car | AUTODOC tips

3K views

Published on: 18/11/2021