Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
CITROËN BERLINGO Box (B9) Electric, CITROËN BERLINGO Box (B9) Electric, CITROËN BERLINGO Box (B9) 1.6 BlueHDi, CITROËN BERLINGO Box (B9) 1.6 BlueHDi, CITROËN BERLINGO Box (B9) 1.6 HDi / BlueHDi, CITROËN BERLINGO Box (B9) 1.6 HDi 4x4, CITROËN BERLINGO Box (B9) 1.6 BlueHDi 4x4 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Brake pad set

Replacement: brake pads – CITROËN BERLINGO Box (B9). Tools you need:

                      Wire brush
                    
                      Nylon cleaning brush
                    
                      WD-40 spray
                    
                      All-purpose cleaning spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      Combination spanner #19
                    
                      Drive socket # 13
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Brake caliper wind back tool
                    
                      Pliers 
                    
                      Water pump pliers
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – CITROËN BERLINGO Box (B9). AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
Warning! Shut down the engine before starting any work – CITROËN BERLINGO Box (B9).

Carry out replacement in the following order:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.

Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – CITROËN BERLINGO Box (B9). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Clean the fastener of the parking brake cable. Use a wire brush. Use WD-40 spray.
Step 8

Release the parking brake cable. Use water pump pliers. Use pliers. Use a crowbar.
Step 9

Clean the brake caliper fasteners. Use a wire brush. Use all-purpose cleaning spray.
Step 10

Unscrew the brake caliper fastening. Use a combination spanner #19. Use a drive socket #13. Use a ratchet wrench.
Step 11

Spread the brake pads. Use a crowbar.
Step 12

Remove the brake caliper.

Replacement: brake pads – CITROËN BERLINGO Box (B9). Professionals recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 13

Remove the brake pads. Use a crowbar.

AUTODOC recommends:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 14

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 15

Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.

Replacement: brake pads – CITROËN BERLINGO Box (B9). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 16

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 17

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 18

Install new brake pads.

Replacement: brake pads – CITROËN BERLINGO Box (B9). AUTODOC experts recommend:
Make sure the pads are installed with linings facing the disc.
Step 19

Install the brake caliper and fix it. Use a combination spanner #19. Use a drive socket #13. Use a torque wrench. Tighten it to 30 Nm torque.
Step 20

Install the parking brake cable into the brake caliper bracket. Use water pump pliers. Use pliers.
Step 21

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 22

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 23

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. CITROËN BERLINGO Box (B9)
Step 24

Screw in the wheel bolts. Use wheel impact socket #17.
Step 25

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 100 Nm torque.
Step 26

Remove the jacks and chocks.

AUTODOC recommends:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 27

Tighten the brake fluid reservoir cap.

Step 28

Close the hood.

Replacement: brake pads – CITROËN BERLINGO Box (B9). AUTODOC experts recommend:
Without starting the engine, press the brake pedal several times until you feel significant resistance.Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the CITROËN Berlingo II Van (B9) model

Citroen Berlingo mk2 tyre size

How to change front brake pads on CITROËN BERLINGO Box (B9) – replacement guide

Free download PDF
1.46 MB
How to change front brake discs on CITROËN BERLINGO Box (B9) – replacement guide

Free download PDF
2 MB
How to change brake drum on CITROËN Berlingo II Van (B9) – replacement guide

Free download PDF
2.25 MB
How to change rear wheel bearing on CITROËN BERLINGO Box (B9) – replacement guide

Free download PDF
1.52 MB
How to change front wheel bearing on CITROËN BERLINGO Box (B9) – replacement guide

Free download PDF
5.01 MB
How to change serpentine belt on CITROËN BERLINGO Box (B9) – replacement guide

Free download PDF
634.88 KB

How to change front brake pads on Citroën Berlingo M – replacement guide

Free download PDF
1.47 MB
How to change rear brake pads on CITROËN Berlingo / Berlingo First Van (M_) – replacement guide

Free download PDF
1.59 MB
How to change rear brake pads on CITROËN BERLINGO (B9) – replacement guide

Free download PDF
1.59 MB
How to change front brake pads on CITROËN BERLINGO Box (B9) – replacement guide

Free download PDF
1.46 MB
How to change front brake pads on CITROËN Berlingo / Berlingo First (MF, GJK, GFK) – replacement guide

Free download PDF
1.29 MB
How to change rear brake pads on CITROËN Berlingo / Berlingo First (MF, GJK, GFK) – replacement guide

Free download PDF
1.59 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

How to unlock your car without a key | AUTODOC tips

2M views

Published on: 15/09/2022
5 mistakes made when washing the engine | AUTODOC tips

32K views

Published on: 22/04/2021
Top 5 brake repair mistakes | AUTODOC tips

197K views

Published on: 27/10/2022
How I started restoring a driveshaft | Drivetrain restoration – Part 1

8K views

Published on: 17/10/2024