Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
BMW 7 (E32) 730 i, iL, BMW 7 (E32) 730 i, iL V8, BMW 7 (E32) 740 i, iL V8, BMW 7 (E32) 750 i, iL V12 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for 7 (E32) and other BMW models

Brake pad set

        Brake pad set for 7 (E32) Petrol (188 hp)
      
        Brake pad set for 7 (E32) Petrol (218 hp)
      
        Brake pad set for 7 (E32) Petrol (286 hp)
      
        Brake pad set for 7 (E32) Petrol (300 hp)

Replacement: brake pads – BMW 7 (E32). Tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Copper grease 
                      
                        Anti-squeal paste
                      
                        HEX bit No.H7.
                      
                        Wheel impact socket #17
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Brake caliper wind back tool
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

Replacement: brake pads – BMW 7 (E32). AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – BMW 7 (E32). Take the following steps:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. BMW 7 (E32)
Step 6

Remove the wheel.
Step 7

Spread the brake pads. Use a crowbar.
Step 8

Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
Step 9

Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
Step 10

Detach the brake caliper retaining spring. Use a crowbar.
Step 11

Remove the brake caliper.

Replacement: brake pads – BMW 7 (E32). Professionals recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
Step 12

Remove the brake pads. Use a crowbar.
Step 13

Disconnect the brake pads wear sensor. Use a crowbar.

Please note!
Some cars are not equipped with the brake pad wear sensor.
Step 14

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – BMW 7 (E32). After applying the spray, wait a few minutes.
Step 15

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 16

Treat the back side of the new brake pads. Use anti-squeal paste.

AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 17

Install new brake pads.

Replacement: brake pads – BMW 7 (E32). Tip from AUTODOC:
Make sure the pads are installed with linings facing the disc.
Step 18

Connect the brake pads wear sensor.
Step 19

Install the brake caliper and fix it. Use HEX No.H7. Use a torque wrench. Tighten it to 30 Nm torque.
Step 20

Install the dust boot caps of the brake caliper guide pins.
Step 21

Install the brake caliper retaining spring.
Step 22

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – BMW 7 (E32). After applying the spray, wait a few minutes.
Step 23

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 24

Install the wheel.

Replacement: brake pads – BMW 7 (E32). Tip:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 25

Screw in the wheel bolts. Use wheel impact socket #17.
Step 26

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 120 Nm torque.

AUTODOC recommends:
BMW 7 (E32) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
Step 27

Remove the jacks and chocks.

Replacement: brake pads – BMW 7 (E32). Tip from AUTODOC experts:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 28

Tighten the brake fluid reservoir cap. Close the hood.

Replacement: brake pads – BMW 7 (E32). AUTODOC recommends:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the BMW 7 (E32) model.

Browse tyres

How to change front wheel bearing on BMW 7 (E32) – replacement guide

Free download PDF
2.07 MB
How to change spark plugs on BMW 7 (E32) – replacement guide

Free download PDF
2.62 MB
How to change rear anti roll bar links on BMW 7 (E32) – replacement guide

Free download PDF
1.77 MB
How to change engine oil and filter on BMW 7 (E32) – replacement guide

Free download PDF
1.79 MB
How to change right engine mounts on BMW 7 (E32) – replacement guide

Free download PDF
2.52 MB
How to change engine oil and filter on BMW E90 diesel – replacement guide

Free download PDF
2.18 MB

How to change front brake pads on BMW 7 (E38) – replacement guide

Free download PDF
1.75 MB
How to change rear brake pads on BMW 7 (E38) – replacement guide

Free download PDF
1.79 MB
How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change front brake pads on BMW E90 – replacement guide

Free download PDF
1.7 MB
How to change rear brake pads on BMW E92 – replacement guide

Free download PDF
1.99 MB
How to change rear brake pads on BMW X3 E83 – replacement guide

Free download PDF
1.64 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.