Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
ALFA ROMEO Brera (939_) 2.0 JTDM (939DXQ1B), ALFA ROMEO Brera (939_) 2.2 JTS (939.DXB11), ALFA ROMEO Brera (939_) 3.2 JTS Q4 (939.DXG22), ALFA ROMEO Brera (939_) 2.4 JTDM 20V (939DXD1B, 939DXD12), ALFA ROMEO Brera (939_) 2.4 JTDM 20V (939DXD1B, 939DXM1B), ALFA ROMEO Brera (939_) 3.2 JTS (939DXG2B, 939DXG1B), ALFA ROMEO Brera (939_) 1.8 TBi (939DXN1B), ALFA ROMEO Brera (939_) 2.0 JTDM (939DXP1B) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for Brera (939_) and other ALFA ROMEO models

Alternative products

Brake pad set

Replacement: brake pads – ALFA ROMEO BRERA. Tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Combination spanner #13
                    
                      Combination spanner #15
                    
                      Wheel impact socket #17
                    
                      Brake caliper wind back tool
                    
                      Torque wrench
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – ALFA ROMEO BRERA. AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – ALFA ROMEO BRERA. Recommended sequence of steps:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the rear of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Important! Hold the wheel while unscrewing the fastening bolts. ALFA ROMEO BRERA
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #15.
Step 9

Remove the brake caliper. Use a crowbar.

Replacement: brake pads – ALFA ROMEO BRERA. AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 10

Remove the brake pads. Use a crowbar.

Replacement: brake pads – ALFA ROMEO BRERA. Tip from AUTODOC:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 11

Remove the retaining springs of the brake pads.

Step 12

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – ALFA ROMEO BRERA. After applying the spray, wait a few minutes.
Step 13

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 14

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

Replacement: brake pads – ALFA ROMEO BRERA. Tip:
After applying the spray, wait a few minutes.
Step 15

Install the retaining springs of the brake pads.
Step 16

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 17

Install new brake pads.

Replacement: brake pads – ALFA ROMEO BRERA. Professionals recommend:
Make sure the pads are installed with linings facing the disc.
Step 18

Install the brake caliper and fix it. Use a combination spanner #13. Use a combination spanner #15. Use a torque wrench. Tighten it to 35 Nm torque.
Step 19

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 20

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – ALFA ROMEO BRERA. After applying the spray, wait a few minutes.
Step 21

Install the wheel.

Replacement: brake pads – ALFA ROMEO BRERA. AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 22

Screw in the wheel bolts. Use wheel impact socket #17.
Step 23

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 120 Nm torque.
Step 24

Remove the jacks and chocks.

Replacement: brake pads – ALFA ROMEO BRERA. AUTODOC recommends:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 25

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
ALFA ROMEO BRERA – Without starting the engine, press the brake pedal several times until it feels firm.
Step 26

Close the hood.

Replacement: brake pads – ALFA ROMEO BRERA. AUTODOC experts recommend:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the ALFA ROMEO Brera (939) model

Alfa Romeo Brera tyre size

How to change front brake pads on ALFA ROMEO Brera (939) – replacement guide

Free download PDF
1.89 MB
How to change rear brake discs on ALFA ROMEO Brera (939_) – replacement guide

Free download PDF
2.18 MB
How to change front brake discs on ALFA ROMEO Brera (939_) – replacement guide

Free download PDF
2.37 MB
How to change front wheel bearing on ALFA ROMEO Brera (939_) – replacement guide

Free download PDF
3.64 MB
How to change rear wheel bearing on ALFA ROMEO Brera (939_) – replacement guide

Free download PDF
2.4 MB
How to change spark plugs on ALFA ROMEO Brera (939_) – replacement guide

Free download PDF
1.22 MB

How to change front brake pads on ALFA ROMEO Brera (939) – replacement guide

Free download PDF
1.89 MB
How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change rear brake pads on Alfa Romeo 159 Sportwagon – replacement guide

Free download PDF
1.74 MB
How to change front brake pads on Alfa Romeo 159 Sportwagon – replacement guide

Free download PDF
1.95 MB
How to change rear brake pads on Alfa Romeo 147 937 – replacement guide

Free download PDF
1.59 MB
How to change front brake pads on Alfa Romeo 147 937 – replacement guide

Free download PDF
1.69 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

The Fast and Easy Way to Fix a Broken Wheel Stud | AUTODOC tips

9K views

Published on: 08/12/2020
Top 5 Mistakes to Avoid for Safe Engine Bay Repairs | AUTODOC Tips

8K views

Published on: 04/08/2023
Prevent Engine Damage: How to Identify Rocker Cover Gasket Issues and Proper Replacement | AUTODOC

5K views

Published on: 03/12/2020
How to Get the Best Deals on Car Parts | Save Money with AUTODOC

2K views

Published on: 03/02/2022