
Disclaimer
How to change rear brake discs on VOLVO S80 I (184) – replacement guide
downloads:
3
Views:
77

Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
VOLVO S80 I (184) 2.9, VOLVO S80 I (184) T6, VOLVO S80 I (184) 2.4, VOLVO S80 I (184) 2.0 T, VOLVO S80 I (184) 2.5 TDI, VOLVO S80 I (184) 2.0, VOLVO S80 I (184) 2.4, VOLVO S80 I (184) 2.9, VOLVO S80 I (184) 2.0 T, VOLVO S80 I (184) 2.4 T, VOLVO S80 I (184) D5, VOLVO S80 I (184) 2.4 Bifuel (CNG), VOLVO S80 I (184) 3.0, VOLVO S80 I (184) T6, VOLVO S80 I (184) 2.4 D, VOLVO S80 I (184) 2.5 T AWD, VOLVO S80 I (184) 2.5 T, VOLVO S80 I (184) 2.3 R, VOLVO S80 I (184) 2.4 LTP, VOLVO S80 I (184) T5 AWD, VOLVO S80 I (184) 2.4 Bifuel (LPG), VOLVO S80 I (184) 2.9, VOLVO S80 I (184) T6 … View more
The steps may slightly vary depending on the car design.
VOLVO S80 I (184) 2.9, VOLVO S80 I (184) T6, VOLVO S80 I (184) 2.4, VOLVO S80 I (184) 2.0 T, VOLVO S80 I (184) 2.5 TDI, VOLVO S80 I (184) 2.0, VOLVO S80 I (184) 2.4, VOLVO S80 I (184) 2.9, VOLVO S80 I (184) 2.0 T, VOLVO S80 I (184) 2.4 T, VOLVO S80 I (184) D5, VOLVO S80 I (184) 2.4 Bifuel (CNG), VOLVO S80 I (184) 3.0, VOLVO S80 I (184) T6, VOLVO S80 I (184) 2.4 D, VOLVO S80 I (184) 2.5 T AWD, VOLVO S80 I (184) 2.5 T, VOLVO S80 I (184) 2.3 R, VOLVO S80 I (184) 2.4 LTP, VOLVO S80 I (184) T5 AWD, VOLVO S80 I (184) 2.4 Bifuel (LPG), VOLVO S80 I (184) 2.9, VOLVO S80 I (184) T6 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Discs for S80 I (184) and other VOLVO models
Brake disc
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
HEX bit No.H7
Impact socket №10
Impact socket №13
Wheel impact socket #19
Brake caliper wind back tool
Ratchet wrench
Torque wrench
Tap wrench
Rubber mallet
Crow bar
Wheel chock
Replacement: brake discs – VOLVO S80 I (TS, XY). Tip from AUTODOC experts:
- Replace the brake disks on the car VOLVO S80 I (TS, XY) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
- The replacement procedure is identical for both brake disks on the same axle.
- When changing the brake discs, always replace the brake pads.
- Please note: all work on the car – VOLVO S80 I (TS, XY) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2Secure the wheels with chocks.
- Step 3Loosen the wheel mounting bolts. Use wheel impact socket #19.
- Step 4Raise the rear of the car and secure on supports.Step 5Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VOLVO S80 I (TS, XY)
- Step 6Remove the wheel.
- Step 7Spread the brake pads. Use a crowbar.
- Step 8Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
- Step 9Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
- Step 10Detach the brake caliper retaining spring. Use a crowbar.
- Step 11Remove the brake caliper.Replacement: brake discs – VOLVO S80 I (TS, XY). Tip from AUTODOC experts:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
- Step 12Remove the brake pads. Use a crowbar.
- Step 13Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
- Step 14Unscrew the caliper bracket fastening. Use a drive socket #13. Use a tap wrench. Use a ratchet wrench.
- Step 15Remove the caliper bracket.
- Step 16Clean the brake disk surface. Use a wire brush. Use WD-40 spray.
- Step 17Unscrew the brake disc fastening. Use a drive socket #10. Use a ratchet wrench.
- Step 18Remove the brake disc.
- Step 19Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease.
- Step 20Install the brake disc.
- Step 21Tighten the brake disc fastening. Use a drive socket #10. Use a torque wrench. Tighten it to 9 Nm torque.
- Step 22Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake discs – VOLVO S80 I (TS, XY). After applying the spray, wait a few minutes.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VOLVO S80 I (TS, 184) model
Popular maintenance tutorials for Volvo S80 1
Complete guides for changing the Brake rotors on different VOLVO S80 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VOLVO S80 I (184)
View more
- BMW E30 Turbo Suspension Swap: Boost Your Handling | AUTODOC project
- DIY rear axle restoration | Drivetrain restoration – Part 2
- How to Make a DIY Foam Sprayer | AUTODOC tips
- How to tighten cylinder head bolts
Most commonly replaced car parts on VOLVO S80
Time to replace parts? Get even better deals in our Shop app.

SCAN ME