Disclaimer
How to change rear brake discs on BMW 1 Convertible (E88) – replacement guide
downloads:
0
Views:
23
Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
BMW 1 Convertible (E88) 120i, BMW 1 Convertible (E88) 125i, BMW 1 Convertible (E88) 118i, BMW 1 Convertible (E88) 120 d, BMW 1 Convertible (E88) 118 d, BMW 1 Convertible (E88) 120 i, BMW 1 Convertible (E88) 120 d, BMW 1 Convertible (E88) 118 d, BMW 1 Convertible (E88) 128i, BMW 1 Convertible (E88) 120 i, BMW 1 Convertible (E88) 120 d, BMW 1 Convertible (E88) 118 i … View more
The steps may slightly vary depending on the car design.
BMW 1 Convertible (E88) 120i, BMW 1 Convertible (E88) 125i, BMW 1 Convertible (E88) 118i, BMW 1 Convertible (E88) 120 d, BMW 1 Convertible (E88) 118 d, BMW 1 Convertible (E88) 120 i, BMW 1 Convertible (E88) 120 d, BMW 1 Convertible (E88) 118 d, BMW 1 Convertible (E88) 128i, BMW 1 Convertible (E88) 120 i, BMW 1 Convertible (E88) 120 d, BMW 1 Convertible (E88) 118 i … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Discs for 1 Convertible (E88) and other BMW models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Anti-squeal paste
Copper grease
Drive socket # 16
HEX bit no.H6.
HEX bit no.H7.
Wheel impact socket #17
Ratchet wrench
Torque wrench
Brake caliper wind back tool
Tap wrench
Impact screwdriver
Crow bar
Fender cover
Wheel chock
Replacement: brake discs – BMW 1 Convertible (E88). Professionals recommend:
- Replace the brake disks on the car BMW 1 Convertible (E88) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
- The replacement procedure is identical for both brake disks on the same axle.
- When changing the brake discs, always replace the brake pads.
- Please note: all work on the car – BMW 1 Convertible (E88) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Remove the wiper arm cover. - Step 4
Unscrew the brake fluid reservoir cap. - Step 5
Secure the wheels with chocks. - Step 6
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 7Raise the rear of the car and secure on supports.Step 8
Unscrew the wheel bolts.Replacement: brake discs – BMW 1 Convertible (E88). AUTODOC recommends:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 9
Remove the wheel. - Step 10
Disconnect the brake pads wear sensor. Use a crowbar.Please note!Some cars are not equipped with the brake pad wear sensor. - Step 11
Remove the dust boot caps of the brake caliper guide pins. Use a crowbar. - Step 12
Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench. - Step 13
Spread the brake pads. Use a crowbar. - Step 14
Detach the brake caliper retaining spring. Use a crowbar. - Step 15
Remove the brake caliper.Replacement: brake discs – BMW 1 Convertible (E88). AUTODOC experts recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary. - Step 16
Remove the brake pads. - Step 17
Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray. - Step 18
Unscrew the caliper bracket fastening. Use a drive socket #16. Use a tap wrench. - Step 19
Remove the caliper bracket. - Step 20
Clean the brake disc fasteners. Use a wire brush. Use WD-40 spray. - Step 21
Unscrew the brake disc fastening. Use HEX No.H6. Use an impact screwdriver. - Step 22
Remove the brake disc. - Step 23
Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease. - Step 24
Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.AUTODOC recommends:Replacement: brake discs – BMW 1 Convertible (E88). After applying the spray, wait a few minutes. - Step 25
Install the brake disc. - Step 26
Tighten the brake disc fastening. Use HEX No.H6. Use a torque wrench. Tighten it to 9 Nm torque. - Step 27
Install the brake caliper bracket.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the BMW 1 Convertible (E88) model
Popular maintenance tutorials for BMW E88
Complete guides for changing the Brake rotors on different BMW 1 SERIES models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your BMW 1 Convertible (E88)
View more
How to Install a New Windscreen Yourself | AUTODOC Expert Tips
How to Swap an M50 Engine in a BMW E30 Turbo | AUTODOC Project
Unveiling the secrets: Detecting vacuum leaks with a Smoke Machine | AUTODOC
Top 5 reasons why your car squeals | AUTODOC Tips
Most commonly replaced car parts on BMW 1 SERIES
Time to replace parts? Get even better deals in our Shop app.

SCAN ME


































