
Disclaimer
How to change rear brake caliper on MERCEDES-BENZ CLK Convertible (A208) – replacement guide
downloads:
0
Views:
2

Recommended replacement interval for the part category Brake caliper : 100000 km
Important!
This replacement procedure can be used for:
MERCEDES-BENZ CLK Convertible (A208) CLK 200 (208.435) … View more
The steps may slightly vary depending on the car design.
MERCEDES-BENZ CLK Convertible (A208) CLK 200 (208.435) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Calipers for CLK Convertible (A208) and other MERCEDES-BENZ models
Brake caliper
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Sealant
Copper grease
Combination spanner #9
Flare nut spanner №14
Drive socket # 17
Wheel impact socket #17
Ratchet wrench
Torque wrench
Flat Screwdriver
Crow bar
Hammer
Pin punch
Brake hose clip
Brake bleeder kit
Wheel chock
Replacement: brake caliper – MERCEDES-BENZ CLK Convertible (A208). Tip from AUTODOC:
- The replacement procedure is identical for the left and right brake calipers on the same axle.
- Please note: all work on the car – MERCEDES-BENZ CLK Convertible (A208) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2Secure the wheels with chocks.
- Step 3Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 4Raise the rear of the car and secure on supports.Step 5Unscrew the wheel bolts.AUTODOC recommends:Important! Hold the wheel while unscrewing the fastening bolts. MERCEDES-BENZ CLK Convertible (A208)
- Step 6Remove the wheel.
- Step 7Remove the brake pads retaining clips. Use a pin punch. Use a hammer.
- Step 8Spread the brake pads. Use a crowbar.
- Step 9Remove the brake pads. Use a flat screwdriver.
- Step 10Clamp the brake hose off using a brake hose clamp.
- Step 11Loosen the brake hose fastening. Use a flare nut spanner #14.
- Step 12Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.Step 13Unscrew the brake caliper fastening. Use a drive socket #17. Use a ratchet wrench.
- Step 14Remove the fastening bolts (2 pieces).Step 15Remove the brake caliper.
- Step 16Disconnect the brake hose.
- Step 17Treat the brake hose. Use a brake cleaner.AUTODOC recommends:Replacement: brake caliper – MERCEDES-BENZ CLK Convertible (A208). After applying the spray, wait a few minutes.Step 18Install and fix the brake hose into a new caliper.
- Step 19Remove the brake hose clamp.
- Step 20Install the brake caliper and fix it.
- Step 21Treat the fastening bolts. Use a sealant.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the MERCEDES-BENZ CLK Convertible (A208) model
Popular maintenance tutorials for Mercedes A208
Complete guides for changing the Brake calipers on different MERCEDES-BENZ CLK models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your MERCEDES-BENZ CLK Convertible (A208)
View more
- How to make an injector test bench yourself
- How I started restoring a driveshaft | Drivetrain restoration – Part 1
- Preventing Engine Failure: Head Gasket Inspection Tutorial | AUTODOC
- 5 Ways You’re Scrubbing Your Car Wrong | AUTODOC Tips
Most commonly replaced car parts on MERCEDES-BENZ CLK
Time to replace parts? Get even better deals in our Shop app.

SCAN ME