
Disclaimer
How to change rear ABS sensor on VW Bora Saloon (1J2) – replacement guide
downloads:
4
Views:
26
Important!
This replacement procedure can be used for:
VW Bora Saloon (1J2) 1.6, VW Bora Saloon (1J2) 2.0, VW Bora Saloon (1J2) 2.3 V5, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.8, VW Bora Saloon (1J2) 1.4 16V, VW Bora Saloon (1J2) 1.9 SDI, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.6 16V, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.6, VW Bora Saloon (1J2) 2.3 V5, VW Bora Saloon (1J2) 1.8 T, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.6 FSI, VW Bora Saloon (1J2) 1.8 T … View more
The steps may slightly vary depending on the car design.
VW Bora Saloon (1J2) 1.6, VW Bora Saloon (1J2) 2.0, VW Bora Saloon (1J2) 2.3 V5, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.8, VW Bora Saloon (1J2) 1.4 16V, VW Bora Saloon (1J2) 1.9 SDI, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.6 16V, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.6, VW Bora Saloon (1J2) 2.3 V5, VW Bora Saloon (1J2) 1.8 T, VW Bora Saloon (1J2) 1.9 TDI, VW Bora Saloon (1J2) 1.6 FSI, VW Bora Saloon (1J2) 1.8 T … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – ABS Sensor for Bora Saloon (1J2) and other VW models
ABS sensor
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Electronic spray
Copper grease
Multipurpose grease
Torque wrench
Torx bit T30
HEX bit No.H5
HEX bit No.H8
Wheel impact socket #17
Ratchet wrench
Flat screwdriver
Water pump pliers
Pin punch
Tap wrench
Hammer
Crow bar
Wheel chock
Replacement: ABS sensor – VW BORA (1J2). Tip from AUTODOC:
- All work should be done with the engine stopped.
Replacement: ABS sensor – VW BORA (1J2). Use the following procedure:
- Step 1Secure the wheels with chocks.Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the rear of the car and secure on supports.Step 4Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VW BORA (1J2)
- Step 5Remove the wheel.
- Step 6Clean the ABS sensor fastener. Use a nylon cleaning brush. Use WD-40 spray.
- Step 7Detach the ABS sensor connector. Use a flat screwdriver.
- Step 8Unscrew the ABS sensor fastener. Use HEX No.H5. Use a ratchet wrench.
- Step 9Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray.
- Step 10Unscrew the brake caliper bracket fasteners. Use HEX No.H8. Use a ratchet wrench. Use a tap wrench.
- Step 11Release the parking brake cable. Use water pump pliers. Use a crowbar.
- Step 12Remove the brake caliper together with its bracket.Replacement: ABS sensor – VW BORA (1J2). AUTODOC experts recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
- Step 13Clean the brake disc fastener. Use a wire brush. Use WD-40 spray.Step 14Unscrew the brake disc fastening. Use Torx T30. Use a ratchet wrench.
- Step 15Remove the brake disc.
- Step 16Disconnect the ABS sensor. Use a pin punch. Use a hammer. Use a crowbar.
- Step 17Clean the ABS sensor mounting seat. Use a wire brush. Use WD-40 spray.
- Step 18Treat the ABS sensor fastener. Use a multipurpose grease.
- Step 19Connect the ABS sensor.
- Step 20Tighten the fastener connecting the ABS sensor to the stub axle. Use HEX No.H5. Use a torque wrench. Tighten it to 6 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Bora Saloon (1J2) model
Popular maintenance tutorials for VW Bora 1j2
Complete guides for changing the Wheel speed sensor on different VW BORA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Bora Saloon (1J2)
View more
- The Ultimate Guide to Engine Bay Cleaning | AUTODOC
- How to remove rust | AUTODOC tips
- TOP 5 mistakes during DIY oil change | AUTODOC tips
- Discover the 4 Key Reasons Your CHECK ENGINE Light Could Be On | AUTODOC Tips
Most commonly replaced car parts on VW BORA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME