Disclaimer
How to change mass air flow sensor on AUDI A4 Avant (8D5, B5) – replacement guide
downloads:
5
Views:
103
Important!
This replacement procedure can be used for:
AUDI A4 Avant (8D5, B5) 1.6, AUDI A4 Avant (8D5, B5) 1.8, AUDI A4 Avant (8D5, B5) 1.6 … View more
The steps may slightly vary depending on the car design.
AUDI A4 Avant (8D5, B5) 1.6, AUDI A4 Avant (8D5, B5) 1.8, AUDI A4 Avant (8D5, B5) 1.6 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Mass Air Flow Sensor for A4 Avant (8D5, B5) and other AUDI models
Alternative products

Electronic spray
Torque wrench
Drive socket # 7
Drive socket # 10
Ratchet wrench
Phillips screwdriver
Fender cover
Replacement: mass air flow sensor – AUDI A4 Avant (8D5, B5). AUTODOC recommends:
- Сlear the trouble codes from the electronic control unit if necessary.
- Make sure that no dust or dirt gets into the air duct components and the throttle body.
- Please note: all work on the car – AUDI A4 Avant (8D5, B5) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Detach the air duct housing from the air filter housing. - Step 4
Unscrew the fasteners of the heat shield of the air filter housing. Use a Phillips screwdriver. - Step 5
Remove the heat shield of the air filter housing. - Step 6
Detach the mass air flow sensor connector. - Step 7
Loosen the fastening clamp connecting the air duct to the air filter housing. Use a drive socket #7. Use a ratchet wrench. - Step 8
Unscrew the MAF sensor fasteners. Use a drive socket #10. Use a ratchet wrench. - Step 9
Remove the mass air flow sensor. - Step 10
Install a new mass air flow sensor. - Step 11
Tighten the MAF sensor fasteners. Use a drive socket #10. Use a torque wrench. Tighten it to 4 Nm torque. - Step 12
Screw the fastening clamp connecting the air duct to the air filter housing. Use a drive socket #7. Use a ratchet wrench.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the AUDI A4 B5 Avant (8D5) model
Popular maintenance tutorials for Audi A4 B5 Avant
Complete guides for changing the MAF sensor on different AUDI A4 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your AUDI A4 Avant (8D5, B5)
View more
How to inspect and troubleshoot your car heater when it’s not working
5 Ways You’re Scrubbing Your Car Wrong | AUTODOC Tips
Reviving Your Car: How to Start After Extended Idle Time | AUTODOC Tips
5 signs of a faulty strut mount and how to fix it
Most commonly replaced car parts on AUDI A4
Time to replace parts? Get even better deals in our Shop app.

SCAN ME



















