Disclaimer
How to change lambda sensor on VW Golf VI Convertible (517) – replacement guide
downloads:
0
Views:
7
Recommended replacement interval for the part category Lambda sensor : 100000 km
Important!
This replacement procedure can be used for:
VW Golf VI Convertible (517) 1.4 TSI, VW Golf VI Convertible (517) 1.4 TSI … View more
The steps may slightly vary depending on the car design.
VW Golf VI Convertible (517) 1.4 TSI, VW Golf VI Convertible (517) 1.4 TSI … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Lambda Sensor for Golf VI Convertible (517) and other VW models
Alternative products

Electronic spray
High-temperature ceramic grease
Torque wrench
Drive socket # 10
22-mm oxygen sensor socket
Ratchet wrench
Thread tap
Fender cover
Replacement: lambda sensor – VW GOLF VI Convertible (517). AUTODOC experts recommend:
- After replacing the oxygen sensor, clear the trouble code from the electronic control unit and let the ECU adapt itself to the new sensor.
- Before getting down to work, start the engine and let it warm up to operating temperature.
- Please note: all work on the car – VW GOLF VI Convertible (517) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Lift the car using a jack or place it over an inspection pit.Step 4
Unscrew the fasteners of the oxygen sensor housing cover. Use a drive socket #10. Use a ratchet wrench. - Step 5
Remove the oxygen sensor housing cover. - Step 6
Detach the oxygen sensor connector. - Step 7
Unscrew the oxygen sensor fastener. Use a 22-mm oxygen sensor socket. Use a ratchet wrench. - Step 8
Remove the oxygen sensor. - Step 9
Cut the thread for the new oxygen sensor. Use a thread tap. Use a ratchet wrench. - Step 10Treat the oxygen sensor. Use high-temperature ceramic grease.Step 11
Install the new oxygen sensor. - Step 12
Tighten the oxygen sensor fastener. Use a 22-mm oxygen sensor socket. Use a torque wrench. Tighten it to 37 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Golf VI Convertible (517) model
Popular maintenance tutorials for VW Golf 6 Convertible
Complete guides for changing the Oxygen sensor on different VW GOLF models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Golf VI Convertible (517)
View more
Easy Steps to Paint Brake Calipers Without Special Skills or High Costs
How to Swap an M50 Engine in a BMW E30 Turbo | AUTODOC Project
Top 5 car noises you shouldn't ignore
Top 5 Mistakes to Avoid for Safe Engine Bay Repairs | AUTODOC Tips
Most commonly replaced car parts on VW GOLF
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




















