
Disclaimer
How to change lambda sensor on VAUXHALL Antara (L07) – replacement guide
downloads:
3
Views:
58

Recommended replacement interval for the part category Lambda sensor : 100000 km
Important!
This replacement procedure can be used for:
VAUXHALL Antara (L07) 2.4, VAUXHALL Antara (L07) 2.4 LPG 4x4, VAUXHALL Antara (L07) 2.4 4x4, VAUXHALL Antara (L07) 2.4 4x4, VAUXHALL Antara (L07) 2.4 … View more
The steps may slightly vary depending on the car design.
VAUXHALL Antara (L07) 2.4, VAUXHALL Antara (L07) 2.4 LPG 4x4, VAUXHALL Antara (L07) 2.4 4x4, VAUXHALL Antara (L07) 2.4 4x4, VAUXHALL Antara (L07) 2.4 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Lambda Sensor for Antara (L07) and other VAUXHALL models
Lambda sensor
Alternative products

Wire brush
WD-40 spray
Electronic spray
High-temperature ceramic grease
Torque wrench
Combination spanner #22
Flare nut wrench #22
Ratchet wrench
Thread tap
Fender cover
Replacement: lambda sensor – VAUXHALL ANTARA (J26, H26). AUTODOC experts recommend:
- After replacing the oxygen sensor, clear the trouble code from the electronic control unit and let the ECU adapt itself to the new sensor.
- Before getting down to work, start the engine and let it warm up to operating temperature.
- Please note: all work on the car – VAUXHALL ANTARA (J26, H26) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Lift the car using a jack or place it over an inspection pit.Step 4Clean the oxygen sensor fastener. Use a wire brush. Use WD-40 spray.
- Step 5Detach the oxygen sensor connector.
- Step 6Unscrew the oxygen sensor fastener. Use a flare nut spanner #22.
- Step 7Remove the oxygen sensor.
- Step 8Cut the thread for the new oxygen sensor. Use a thread tap. Use a ratchet wrench.
- Step 9Treat the oxygen sensor. Use high-temperature ceramic grease.Step 10Install the new oxygen sensor.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VAUXHALL Antara (L07) model
Popular maintenance tutorials for VAUXHALL ANTARA (J26, H26)
Complete guides for changing the Oxygen sensor on different VAUXHALL ANTARA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VAUXHALL Antara (L07)
View more
- How I started restoring a driveshaft | Drivetrain restoration – Part 1
- Easy Steps to Paint Brake Calipers Without Special Skills or High Costs
- 5 causes of turbocharger failure and how to avoid them
- DIY brake caliper restoration | AUTODOC tips
Most commonly replaced car parts on VAUXHALL ANTARA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME