
Disclaimer
How to change lambda sensor on MERCEDES-BENZ S-Class Coupe (C140) – replacement guide
downloads:
4
Views:
22

Recommended replacement interval for the part category Lambda sensor : 100000 km
Important!
This replacement procedure can be used for:
MERCEDES-BENZ S-Class Coupe (C140) SEC/CL 420 (140.063) … View more
The steps may slightly vary depending on the car design.
MERCEDES-BENZ S-Class Coupe (C140) SEC/CL 420 (140.063) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Lambda Sensor for S-Class Coupe (C140) and other MERCEDES-BENZ models
Lambda sensor
Alternative products

Wire brush
WD-40 spray
Electronic spray
High-temperature ceramic grease
Torque wrench
Combination spanner #22
Drive socket # 8
22-mm oxygen sensor socket
Ratchet wrench
Thread tap
Fender cover
Replacement: lambda sensor – MERCEDES-BENZ S-CLASS Coupe (C140). AUTODOC experts recommend:
- After replacing the oxygen sensor, clear the trouble code from the electronic control unit and let the ECU adapt itself to the new sensor.
- All work should be done with the engine stopped.
Replacement: lambda sensor – MERCEDES-BENZ S-CLASS Coupe (C140). Recommended sequence of steps:
- Step 1Before getting down to work, start the engine and let it warm up to operating temperature.Step 2Open the bonnet.Step 3Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 4Shut off the engine.Step 5Lift the car using a jack or place it over an inspection pit.Step 6Undo the fasteners of the oil pan lower cover. Use a drive socket #8. Use a ratchet wrench.
- Step 7Remove the oil pan cover.
- Step 8Detach the oxygen sensor connector.
- Step 9Clean the oxygen sensor fastener. Use a wire brush. Use WD-40 spray.
- Step 10Unscrew the oxygen sensor fastener. Use a 22-mm oxygen sensor socket. Use a ratchet wrench.
- Step 11Remove the oxygen sensor.
- Step 12Cut the thread for the new oxygen sensor. Use a thread tap. Use a ratchet wrench.
- Step 13Treat the oxygen sensor. Use high-temperature ceramic grease.
- Step 14Install the new oxygen sensor.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the MERCEDES-BENZ S-Class Coupe (C140) model
Popular maintenance tutorials for Mercedes C140
Complete guides for changing the Oxygen sensor on different MERCEDES-BENZ S-CLASS models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your MERCEDES-BENZ S-Class Coupe (C140)
View more
- How to tighten cylinder head bolts
- How to fix your car with AUTODOC CLUB
- DIY manual gearbox restoration | Drivetrain restoration – Part 3
- How to Prevent Premature Wear on Your Car Boot Damper | AUTODOC
Most commonly replaced car parts on MERCEDES-BENZ S-CLASS
Time to replace parts? Get even better deals in our Shop app.

SCAN ME