Disclaimer
How to change lambda sensor on AUDI A6 Avant (4G5, 4GD, C7) – replacement guide
downloads:
19
Views:
211
Recommended replacement interval for the part category Lambda sensor : 100000 km
Important!
This replacement procedure can be used for:
AUDI A6 Avant (4G5, 4GD, C7) 2.0 TFSI … View more
The steps may slightly vary depending on the car design.
AUDI A6 Avant (4G5, 4GD, C7) 2.0 TFSI … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Lambda Sensor for A6 Avant (4G5, 4GD, C7) and other AUDI models
Alternative products

Electronic spray
High-temperature ceramic grease
Torque wrench
Drive socket # 10
22-mm oxygen sensor socket
Ratchet wrench
Thread tap
Fender cover
Replacement: lambda sensor – AUDI A6 Avant (4G5, C7, 4GD). AUTODOC experts recommend:
- After replacing the oxygen sensor, clear the trouble code from the electronic control unit and let the ECU adapt itself to the new sensor.
- Before getting down to work, start the engine and let it warm up to operating temperature.
- Please note: all work on the car – AUDI A6 Avant (4G5, C7, 4GD) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Lift the car using a jack or place it over an inspection pit.Step 4
Unscrew the fasteners of the oxygen sensor housing cover. Use a drive socket #10. Use a ratchet wrench. - Step 5
Remove the oxygen sensor housing cover. - Step 6
Detach the oxygen sensor connector. - Step 7
Unscrew the oxygen sensor fastener. Use a 22-mm oxygen sensor socket. Use a ratchet wrench. - Step 8
Remove the oxygen sensor. - Step 9
Cut the thread for the new oxygen sensor. Use a thread tap. Use a ratchet wrench. - Step 10Treat the oxygen sensor. Use high-temperature ceramic grease.Step 11
Install the new oxygen sensor. - Step 12
Tighten the oxygen sensor fastener. Use a 22-mm oxygen sensor socket. Use a torque wrench. Tighten it to 37 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the AUDI A6 C7 Avant (4G5, 4GD) model
Popular maintenance tutorials for Audi A6 C7 Avant
Complete guides for changing the Oxygen sensor on different AUDI A6 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your AUDI A6 Avant (4G5, 4GD, C7)
View more
How to Swap an M50 Engine in a BMW E30 Turbo | AUTODOC Project
5 possible reasons why your car heater isn't working
How to Get the Best Deals on Car Parts | Save Money with AUTODOC
How to replace a timing chain yourself
Most commonly replaced car parts on AUDI A6
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




















