Important!

This replacement procedure can be used for:
NISSAN TIIDA Hatchback 1.8, NISSAN TIIDA Hatchback 1.8, NISSAN TIIDA Hatchback 1.6 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Ignition coil

Replacement: ignition coil – NISSAN TIIDA Hatchback. List of the tools you'll need:

                      Electronic spray
                    
                      Torque wrench
                    
                      Drive socket # 8 
                    
                      Drive socket # 10 
                    
                      Ratchet wrench
                    
                      Round-nose pliers
                    
                      Flat screwdriver
                    
                      Microfibre towel
                    
                      Fender cover

Buy tools

Replacement: ignition coil – NISSAN TIIDA Hatchback. AUTODOC experts recommend:

The replacement procedure is the same for the ignition coils of all cylinders.
All work should be done with the engine stopped.

Replacement: ignition coil – NISSAN TIIDA Hatchback. Use the following procedure:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Disconnect the crankcase ventilation hose from the air duct. Use round-nose pliers.
Step 4

Unscrew the clamps and fasteners on the air filter intake pipe. Use a drive socket #10. Use a ratchet wrench.
Step 5

Disconnect the air intake pipe from the air filter housing.

Step 6

Unscrew the fasteners connecting the throttle valve to the intake manifold. Use a drive socket #8. Use a ratchet wrench.
Step 7

Release the clamp and detach the connector and the vacuum hose from the intake manifold near the throttle valve. Use round-nose pliers.
Step 8

Unscrew the fasteners of the intake manifold bracket. Use a drive socket #10.
Step 9

Detach the vacuum booster hose from the intake manifold.
Step 10

Unscrew the intake manifold fasteners. Use a drive socket #10. Use a ratchet wrench.
Step 11

Remove the intake manifold.
Step 12

Cover the intake manifold passages with a microfibre towel to prevent dust and dirt from getting inside.
Step 13

Detach the connector from the ignition coil.
Step 14

Unscrew the ignition coil bracket. Use a drive socket #10.
Step 15

Take out the ignition coil from the spark plug well.
Step 16

Clean dirt, dust and debris from inside the spark plug well.

Step 17

Install the new ignition coil to the spark plug well. Make sure you hear a click indicating that it is locked in place.
Step 18

Treat the ignition coil connector with electronic spray. The spray will protect the electrical contacts from corrosion, oxidation, and will reduce the contact resistance.

Step 19

Tighten the ignition coil fastening. Use a drive socket #10. Use a torque wrench. Tighten it to 7 nm torque.
Step 20

Plug in the ignition coil connector.
Step 21

Remove the microfibre towel from the intake manifold.
Step 22

Remove the intake manifold gasket. Use a flat screwdriver.
Step 23

Install the new intake manifold gasket.
Step 24

Install the intake manifold.
Step 25

Tighten the intake manifold fasteners. Use a drive socket #10. Use a torque wrench. Tighten it to 27 nm torque.
Step 26

Tighten the fasteners of the intake manifold bracket. Use a drive socket #10. Use a torque wrench. Tighten it to 10 nm torque.
Step 27

Attach the vacuum booster hose to the intake manifold.
Step 28

Squeeze and install the vacuum booster hose clamp. Use round-nose pliers.
Step 29

Install the throttle valve on the intake manifold.
Step 30

Tighten the throttle valve fasteners. Use a drive socket #8. Use a torque wrench. Tighten it to 10 nm torque.
Step 31

Attach the connector and the vacuum hose to the intake manifold near the throttle valve. Use round-nose pliers.
Step 32

Connect the air intake pipe to the air filter housing.
Step 33

Connect the crankcase ventilation hose to the air duct. Use round-nose pliers.
Step 34

Tighten the clamp and the fasteners on the air filter intake pipe. Use a drive socket #10. Use a ratchet wrench.

Step 35

Run the engine for a few minutes. This is necessary in order to make sure that the component operates properly.

Step 36

Shut off the engine.

Step 37

Remove the fender protection cover.

Step 38

Close the hood.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the NISSAN Tiida Hatchback (C11) model

Nissan Tiida C11 tyre size

How to change serpentine belt on NISSAN TIIDA Hatchback – replacement guide

Free download PDF
1.62 MB
How to change spark plugs on NISSAN TIIDA Hatchback – replacement guide

Free download PDF
2.02 MB
How to change rear brake pads on NISSAN Tiida Hatchback (C11) – replacement guide

Free download PDF
1.72 MB
How to change front windshield wipers on NISSAN TIIDA Hatchback – replacement guide

Free download PDF
512 KB
How to change engine oil and filter on NISSAN Tiida Hatchback (C11) – replacement guide

Free download PDF
2.46 MB
How to change front anti roll bar links on NISSAN TIIDA Hatchback – replacement guide

Free download PDF
1.11 MB

How to change ignition coil on NISSAN Tiida Saloon (SC11X) – replacement guide

Free download PDF
2.84 MB
How to change ignition coil on a car – replacement tutorial

Universal

Free download PDF
1.98 MB
How to change ignition coil on Nissan Qashqai J10 – replacement guide

Free download PDF
3.06 MB
How to change ignition coil on NISSAN Note I (E11, NE11) – replacement guide

Free download PDF
2.82 MB
How to change ignition coil on NISSAN X-Trail (T31) – replacement guide

Free download PDF
2.82 MB
How to change ignition coil on NISSAN Micra III Hatchback (K12) – replacement guide

Free download PDF
2.82 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

5 more brake repair mistakes | Stop making these brake repair mistakes

9K views

Published on: 22/01/2025
Petrol or diesel: The engine showdown! | AUTODOC

4K views

Published on: 04/05/2021
5 most common causes of oil leaks | AUTODOC tips

69K views

Published on: 30/03/2023
Why Checking Your Oil is Crucial for Engine Performance

6K views

Published on: 23/02/2023