When to replace the Glow Plugs on your RENAULT LAGUNA
Recommended replacement interval for the part category Glow plug : 30000 km
Important!
This replacement procedure can be used for:
RENAULT LAGUNA III (BT0/1) 1.5 dCi (BT00, BT0A, BT0T, BT1J) View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Glow Plugs for LAGUNA III (BT0/1) and other RENAULT models
Tools
Replacement: glow plugs – RENAULT LAGUNA III (BT0/1). Tools you might need:
Injector & glow plug grease
Torque wrench
Drive socket # 10
Spark plug socket # 10
Ratchet wrench
Flat Screwdriver
Combination pliers
Crow bar
Microfibre towel
Fender cover
Replacement: glow plugs – RENAULT LAGUNA III (BT0/1). AUTODOC recommends:
  • The replacement procedure is identical for all glow plugs.
  • Before getting down to work, start the engine and let it warm up to operating temperature.
  • Wear gloves to protect your hands from hot surfaces.
  • All work should be done with the engine stopped.
Carry out replacement in the following order:
  1. Step 1
    Open the bonnet.
    Step 2
    Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
    Step 3
    How to change Glow Plugs on Renault Laguna 3 2007 - free PDF and video manuals
    Disconnect the air intake pipe fastening. Use a drive socket #10. Use a ratchet wrench.
  2. Step 4
    How to replace RENAULT LAGUNA III (BT0/1) 1.5 dCi 2008 Glow Plugs - step-by-step manuals and video guides
    Detach the air intake hose clamp. Use combination pliers. Use a crowbar.
  3. Step 5
    Renault Laguna 3 2.0 dCi (BT01, BT08, BT09, BT0E, BT0K, BT12, BT1C, BT1D,... 2009 Glow Plugs replacement: free workshop manuals
    Remove the air intake pipe.
  4. Step 6
    Changing Glow Plugs on RENAULT LAGUNA III (BT0/1) 2.0 16V 2010 by yourself
    Cover the air intake hose with a microfibre towel to prevent dust and dirt from getting into the system.
  5. Step 7
    How to remove RENAULT LAGUNA 2.0 dCi GT (BT11, BT1E, BT1N) 2011 Glow Plugs - online easy-to-follow instructions
    Detach the engine wiring harness. Use a flat screwdriver.
  6. Step 8
    How to replace Glow Plugs on RENAULT LAGUNA III (BT0/1) 2012: download PDF manuals and video instructions
    Unscrew the engine cover fastener. Use a drive socket #10. Use a ratchet wrench.
  7. Step 9
    How hard is it to do yourself: Glow Plugs replacement on Renault Laguna 3 2.0 16V Turbo 2013 - download illustrated guide
    Remove the engine cover.
    Replacement: glow plugs – RENAULT LAGUNA III (BT0/1). Tip from AUTODOC experts:
    Do not apply excessive force when removing the part. Otherwise you may damage it.
  8. Step 10
    Need to know how to renew Glow Plugs on RENAULT LAGUNA 2014? This free workshop manual will help you to do it yourself
    Clean dirt, dust and debris from inside the spark plug wells.
  9. Step 11
    Changing of Glow Plugs on Renault Laguna 3 2015 won't be an issue if you follow this illustrated step-by-step guide
    Detach the glow plug wiring connectors.
  10. Step 12
    RENAULT LAGUNA 2.0 GT Glow Plugs replacement: online guides and video tutorials
    Unscrew the glow plugs. Use the spark plug socket #10. Use a ratchet wrench.
  11. Step 13
    Replacing Glow Plugs on Renault Laguna 3 2008 1.5 dCi by yourself
    Remove the glow plugs.
  12. Step 14
    LAGUNA III (BT0/1) 2.0 dCi GT (BT11, BT1E, BT1N) 2009 Glow Plugs DIY replacement workshop manual
    Treat the glow plugs. Use the injector & glow plug grease.
    Please note!
    Do not touch the heating element as fingerprints may cause malfunction.
  13. Step 15
    How to change Glow Plugs on RENAULT LAGUNA III (BT0/1) 2010 - tips and tricks
    Install new glow plugs to their mounting seats.
  14. Step 16
    Step-by-step recommendations for DIY replacement Renault Laguna 3 2011 2.0 dCi GT (BT11, BT1E, BT1N) Glow Plugs
    Tighten the glow plugs. Use the spark plug socket #10. Use a torque wrench. Tighten it to 15 nm torque.
    Replacement: glow plugs – RENAULT LAGUNA III (BT0/1). Tip from AUTODOC:
    Don't tighten the plugs with excessive force. Exceeding tightening torque can damage the thread connection. Be careful when working with a spark plug wrench. Its skewing can cause damage to the threaded connection.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the RENAULT Laguna III Hatchback (BT) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
RENAULT LAGUNA III (BT0/1) Glow Plugs replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY RENAULT LAGUNA III (BT0/1) Glow Plugs replacement - online guide
Tips & tricks for your RENAULT LAGUNA III (BT0/1)
View more
  • How to change Glow plug on RENAULT LAGUNA III (BT0/1) 2.0 dCi (BT07, BT0J, BT14, BT1A, BT1S) - replacement tricks
    How to detect vacuum leaks using a smoke machine | AUTODOC
  • Changing Heater plugs Renault Laguna 3 1.5 dCi - Replacement Tips
    How to wash your car in winter | AUTODOC tips
  • Maintenance Hacks - RENAULT LAGUNA III (BT0/1) 2.0 dCi (BT01, BT08, BT09, BT0E, BT0K, BT12, BT1C, BT1D,... Heater plug replacement guide
    What to do if your car's air conditioning isn't working properly | AUTODOC tips
  • Replace Diesel glow plugs on Renault Laguna 3 - free video tips
    Replacing your engine cooling fan | AUTODOC tips