How to change fuel filter on PEUGEOT 508 II SW (FE_, F4_) – replacement guide
downloads:
6
Views:
66
0
Users voted – 0
Recommended replacement interval for the part category Fuel filter : 12month / 15000km
Important!
This replacement procedure can be used for:
PEUGEOT 508 II SW (FE_, F4_) 1.6 THP 165 (F45GYV),
PEUGEOT 508 II SW (FE_, F4_) 1.6 PureTech 225 (F45GGR),
PEUGEOT 508 II SW (FE_, F4_) 1.6 PureTech 180
…
View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Fuel Filter for 508 II SW (FE_, F4_) and other PEUGEOT models
Make sure that the fuel filter is positioned correctly. Consider the fuel flow direction mark.During installation, take care to prevent dust and dirt from getting into the fuel filter housing.Take care to only use quality filters.
Step 11
Connect the fuel supply lines to the fuel filter.
Step 12
Install the fuel lines on the car body.
Step 13
Take the fluid container away from under the fuel filter.
Step 14
Lower the car.
Step 15
Tighten the fuel filler cap.
Step 16
Close the fuel door.
Replacement: fuel filter – PEUGEOT 508 II SW (FE_, F4_). Tip from AUTODOC:
Before starting off, switch the ignition on and off several times. This should be done to activate the fuel pump to make it pump fuel through the fuel system.
Step 17
Run the engine for a few minutes. This is necessary in order to make sure that the component operates properly.
Step 18
Shut off the engine.
Replacement: fuel filter – PEUGEOT 508 II SW (FE_, F4_). Tip from AUTODOC experts:
To protect the environment from pollution, be sure to dispose of the used filters at special collection points.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the PEUGEOT 508 II SW (FE_, F4_) model