Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 11
Remove the brake pads.
Replacement: brake pads – VAUXHALL TIGRA TwinTop. Tip from AUTODOC:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 12
Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.
AUTODOC recommends:
Replacement: brake pads – VAUXHALL TIGRA TwinTop. After applying the spray, wait a few minutes.
Step 13
Treat the brake caliper piston. Use a brake cleaner.
Replacement: brake pads – VAUXHALL TIGRA TwinTop. Tip from AUTODOC experts:
After applying the spray, wait a few minutes.
Step 14
Press in the brake caliper piston. Use brake caliper wind back tool.
Step 15
Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.