Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
VAUXHALL Corsavan Mk II (C) (X01) 1.2 16V (F08), VAUXHALL Corsavan Mk II (C) (X01) 1.7 DI 16V (F08), VAUXHALL Corsavan Mk II (C) (X01) 1.7 DTI 16V (F08), VAUXHALL Corsavan Mk II (C) (X01) 1.3 CDTI 16V (F08), VAUXHALL Corsavan Mk II (C) (X01) 1.2 16V Dualfuel (F08), VAUXHALL Corsavan Mk II (C) (X01) 1.2 16V (F08) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for Corsavan Mk II (C) (X01) and other VAUXHALL models

Alternative products

Brake pad set

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). Tools you need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Drive socket # 12 
                    
                      Wheel impact socket #17
                    
                      Brake caliper wind back tool
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). Tip:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). Recommended sequence of steps:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). AUTODOC experts recommend:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Spread the brake pads. Use a crowbar.
Step 9

Unscrew the brake caliper fastening. Use a drive socket #12. Use a ratchet wrench.
Step 10

Remove the brake caliper.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). AUTODOC recommends:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 11

Remove the brake pads.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). Tip from AUTODOC:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 12

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). After applying the spray, wait a few minutes.
Step 13

Treat the brake caliper piston. Use a brake cleaner.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). Tip from AUTODOC experts:
After applying the spray, wait a few minutes.
Step 14

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 15

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). Professionals recommend:
Make sure the disc surface is clean before installing the pads.
Step 16

Install new brake pads.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). AUTODOC recommends:
Make sure the pads are installed with linings facing the disc.
Step 17

Install the brake caliper and fix it.
Step 18

Tighten the brake caliper fasteners. Use a drive socket #12. Use a torque wrench. Tighten it to 27 Nm torque.

AUTODOC recommends:
VAUXHALL CORSAVAN Mk II (C) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
Step 19

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 20

Clean the brake disk surface. Use a brake cleaner.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). Tip:
After applying the spray, wait a few minutes.
Step 21

Install the wheel.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). AUTODOC experts recommend:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 22

Screw in the wheel bolts. Use wheel impact socket #17.
Step 23

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 110 Nm torque.
Step 24

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). Check the brake fluid level in the reservoir and top up if necessary.
Step 25

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
VAUXHALL CORSAVAN Mk II (C) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
Step 26

Close the hood.

Replacement: brake pads – VAUXHALL CORSAVAN Mk II (C). Tip from AUTODOC:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the VAUXHALL Corsavan Mk2 (C) (X01) model

VAUXHALL CORSAVAN Mk II (C) tyre size

How to change front brake discs on VAUXHALL Corsavan Mk II (C) (X01) – replacement guide

Free download PDF
1.74 MB
How to change rear brake shoes on VAUXHALL Corsavan Mk II (C) (X01) – replacement guide

Free download PDF
1.57 MB
How to change front wheel bearing on VAUXHALL Corsavan Mk II (C) (X01) – replacement guide

Free download PDF
2.88 MB
How to change serpentine belt on VAUXHALL Corsavan Mk II (C) (X01) – replacement guide

Free download PDF
1.43 MB
How to change spark plugs on VAUXHALL Corsavan Mk II (C) (X01) petrol – replacement guide

Free download PDF
1.16 MB
How to change front windshield wipers on VAUXHALL Corsavan Mk II (C) (X01) – replacement guide

Free download PDF
624.64 KB

How to change front brake pads on VAUXHALL Corsa Mk III (D) Hatchback (S07) – replacement guide

Free download PDF
1.49 MB
How to change front brake pads on VAUXHALL Corsa Mk IV (E) Hatchback (X15) – replacement guide

Free download PDF
1.5 MB
How to change front brake pads on VAUXHALL Corsa Mk II (C) Hatchback (X01) – replacement guide

Free download PDF
1.49 MB
How to change rear brake pads on VAUXHALL Corsa Mk II (C) Hatchback (X01) – replacement guide

Free download PDF
1.48 MB
How to change front brake pads on VAUXHALL Corsa Mk I (B) Hatchback (S93) – replacement guide

Free download PDF
1.47 MB
How to change front brake pads on VAUXHALL Corsavan Mk III (D) (S07) – replacement guide

Free download PDF
1.47 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Top Automatic Transmission Blunders You Must Dodge | AUTODOC Insights

7K views

Published on: 26/01/2021
5 mistakes when replacing consumables

5K views

Published on: 06/02/2025
5 tools that make car repair incredibly simple | AUTODOC tips

47K views

Published on: 25/01/2024
Petrol or diesel: The engine showdown! | AUTODOC

4K views

Published on: 04/05/2021