Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
PEUGEOT 207 CC (WD_) 1.6 16V, PEUGEOT 207 CC (WD_) 1.6 16V Turbo, PEUGEOT 207 CC (WD_) 1.6 HDi, PEUGEOT 207 CC (WD_) 1.6 HDi, PEUGEOT 207 CC (WD_) 1.6 16V Turbo … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for 207 CC (WD_) and other PEUGEOT models

Brake pad set

        Brake pad set for 207 CC Petrol (120 hp)
      
        Brake pad set for 207 CC Petrol (150 hp)
      
        Brake pad set for 207 CC Diesel (109 hp)
      
        Brake pad set for 207 CC Diesel (112 hp)
      
        Brake pad set for 207 CC Petrol (156 hp)

Replacement: brake pads – PEUGEOT 207 CC (WD_). Tools you might need:

                        Wire brush
                      
                        Nylon cleaning brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Anti-squeal paste
                      
                        Copper grease 
                      
                        Torque wrench
                      
                        Combination spanner #13
                      
                        Drive socket # 13
                      
                        Wheel impact socket #17
                      
                        Brake caliper wind back tool
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

Replacement: brake pads – PEUGEOT 207 CC (WD_). AUTODOC recommends:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – PEUGEOT 207 CC (WD_). Recommended sequence of steps:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.

Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – PEUGEOT 207 CC (WD_). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the brake caliper fastening. Use a combination spanner #13.
Step 9

Spread the brake pads. Use a crowbar.
Step 10

Remove the brake caliper.

Replacement: brake pads – PEUGEOT 207 CC (WD_). AUTODOC experts recommend:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 11

Remove the brake pads. Use a crowbar.

AUTODOC recommends:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 12

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 13

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 14

Install new brake pads.

Replacement: brake pads – PEUGEOT 207 CC (WD_). Tip from AUTODOC:
Make sure the pads are installed with linings facing the disc.
Step 15

Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 16

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 17

Install the brake caliper and fix it. Use a drive socket #13. Use a torque wrench. Tighten it to 30 Nm torque.
Step 18

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 19

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 20

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. PEUGEOT 207 CC (WD_)
Step 21

Screw in the wheel bolts. Use wheel impact socket #17.
Step 22

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 100 Nm torque.
Step 23

Remove the jacks and chocks.

AUTODOC recommends:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 24

Tighten the brake fluid reservoir cap. Close the hood.

AUTODOC recommends:
PEUGEOT 207 CC (WD_) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the PEUGEOT 207 CC model.

Browse tyres

How to change rear brake discs on PEUGEOT 207 CC – replacement guide

Free download PDF
2.31 MB
How to change front brake discs on PEUGEOT 207 CC – replacement guide

Free download PDF
1.89 MB
How to change rear brake pads on PEUGEOT 207 CC – replacement guide

Free download PDF
2.47 MB
How to change front wheel bearing on PEUGEOT 207 CC – replacement guide

Free download PDF
5.97 MB
How to change rear wheel bearing on PEUGEOT 207 CC – replacement guide

Free download PDF
2.15 MB
How to change serpentine belt on PEUGEOT 207 CC – replacement guide

Free download PDF
1.41 MB

How to change front brake pads on Peugeot 207 hatchback – replacement guide

Free download PDF
1.38 MB
How to change rear brake pads on Peugeot 207 hatchback – replacement guide

Free download PDF
2.56 MB
How to change rear brake pads on PEUGEOT 207 CC – replacement guide

Free download PDF
2.47 MB
How to change rear brake pads on PEUGEOT 207 SW – replacement guide

Free download PDF
2.47 MB
How to change front brake pads on PEUGEOT 207 SW – replacement guide

Free download PDF
1.43 MB
How to change rear brake pads on PEUGEOT 207 Saloon – replacement guide

Free download PDF
2.47 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

TOP 5 mistakes during DIY oil change | AUTODOC tips

34K views

Published on: 17/06/2021
What to do if your car's air conditioning isn't working properly | AUTODOC tips

6K views

Published on: 05/08/2021
Important differences between car tools | AUTODOC tips

7K views

Published on: 16/12/2021
How to Make a DIY Foam Sprayer | AUTODOC tips

206K views

Published on: 23/06/2022