Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
MERCEDES-BENZ VITO Box (W447) 109 CDI (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 111 CDI (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 114 CDI (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 116 CDI (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 119 CDI / BlueTEC (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 114 CDI 4x4 (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 116 CDI 4x4 (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 119 CDI / BlueTEC 4x4 (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 110 CDI (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 114 CDI (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 114 CDI (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 116 CDI (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 116 CDI 4x4 (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 119 CDI (447.601, 447.603, 447.605), MERCEDES-BENZ VITO Box (W447) 119 CDI 4x4 (447.601, 447.603, 447.605) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Brake pad set

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). List of the tools you'll need:

                      Wire brush
                    
                      Nylon cleaning brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Anti-squeal paste
                    
                      Copper grease 
                    
                      Torque wrench
                    
                      HEX bit no.H6.
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Flat Screwdriver
                    
                      Brake caliper wind back tool
                    
                      Round-nose pliers
                    
                      Crow bar
                    
                      Wheel chock

Buy tools

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). AUTODOC experts recommend:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). Use the following procedure:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Remove the dust boot caps of the brake caliper guide pins.
Step 8

Disconnect the brake pad wear sensor plug. Use round-nose pliers.

Please note!
Some cars are not equipped with the brake pad wear sensor.
Step 9

Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray.
Step 10

Unscrew the brake caliper fastening. Use HEX No.H6. Use a ratchet wrench.
Step 11

Remove the guide pins from the brake caliper.

Step 12

Spread the brake pads. Use a crowbar.

Step 13

Remove the brake caliper.

AUTODOC recommends:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 14

Remove the brake pads.

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). AUTODOC experts recommend:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 15

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). After applying the spray, wait a few minutes.
Step 16

Remove the retaining springs of the brake pads. Use a flat screwdriver.
Step 17

Install the retaining springs of the brake pads.
Step 18

Remove the brake pad wear sensor from the brake pad. Use a flat screwdriver.

Step 19

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). Tip from AUTODOC:
Make sure the disc surface is clean before installing the pads.
Step 20

Install the wear sensor on the brake pads.

Step 21

Install new brake pads. Use a flat screwdriver.

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). Professionals recommend:
Make sure the pads are installed with linings facing the disc.
Step 22

Treat the brake caliper piston. Use a nylon cleaning brush. Use a brake cleaner.

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 23

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 24

Install the brake caliper and fix it.
Step 25

Screw in the guide pins.

Step 26

Tighten the brake caliper fasteners. Use HEX No.H6. Use a torque wrench. Tighten it to 35 Nm torque.
Step 27

Connect the brake pad wear sensor plug.
Step 28

Install the dust boot caps of the brake caliper guide pins. Use a flat screwdriver.
Step 29

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 30

Clean the brake disk surface. Use a brake cleaner.

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). Tip from AUTODOC experts:
After applying the spray, wait a few minutes.
Step 31

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. MERCEDES-BENZ VITO Box (W447)
Step 32

Screw in the wheel bolts. Use wheel impact socket #17.
Step 33

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 130 Nm torque.
Step 34

Remove the jacks and chocks.

Replacement: brake pads – MERCEDES-BENZ VITO Box (W447). AUTODOC recommends:
Check the brake fluid level in the expansion tank and refill if necessary.
Step 35

Tighten the brake fluid reservoir cap. Close the hood.

AUTODOC recommends:
MERCEDES-BENZ VITO Box (W447) – Press the brake pedal several times with the engine shut down until you feel the resistance built up.Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the MERCEDES-BENZ Vito Van (W447) model

Mercedes Vito W447 tyre size

How to change front brake discs on MERCEDES-BENZ VITO Box (W447) – replacement guide

Free download PDF
2.2 MB
How to change serpentine belt on Mercedes W245 – replacement guide

Free download PDF
1.52 MB
How to change engine oil and filter on Mercedes W204 – replacement guide

Free download PDF
1.84 MB
How to change fuel filter on Mercedes W204 – replacement guide

Free download PDF
1.64 MB
How to change engine oil and filter on Mercedes W211 – replacement guide

Free download PDF
2.7 MB
How to change front lower arm on Mercedes W203 – replacement guide

Free download PDF
2.02 MB

How to change rear brake pads on Mercedes Vito W639 – replacement guide

Free download PDF
1.72 MB
How to change front brake pads on Mercedes Vito W639 – replacement guide

Free download PDF
1.94 MB
How to change front brake pads on MERCEDES-BENZ VITO / MIXTO Box (W639) – replacement guide

Free download PDF
1.8 MB
How to change rear brake pads on MERCEDES-BENZ VITO / MIXTO Box (W639) – replacement guide

Free download PDF
1.65 MB
How to change front brake pads on MERCEDES-BENZ VITO Tourer (W447) – replacement guide

Free download PDF
1.81 MB
How to change front brake pads on MERCEDES-BENZ VITO Mixto (W447) – replacement guide

Free download PDF
1.81 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

How I started restoring a driveshaft | Drivetrain restoration – Part 1

8K views

Published on: 17/10/2024
How to remove rust | AUTODOC tips

27K views

Published on: 16/09/2021
5 possible reasons why your car heater isn't working

7K views

Published on: 21/11/2024
Understanding Airbag Light Warnings | Essential Tips for Car Safety

6K views

Published on: 10/04/2023