Disclaimer
How to change front brake discs on VW PASSAT (3B2) – replacement guide
downloads:
0
Views:
8
Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
VW PASSAT (3B2) 1.6, VW PASSAT (3B2) 1.8, VW PASSAT (3B2) 1.8 T, VW PASSAT (3B2) 2.3 VR5, VW PASSAT (3B2) 2.8 V6 Syncro/4motion, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 2.8 V6, VW PASSAT (3B2) 1.8 Syncro/4motion, VW PASSAT (3B2) 1.9 TDI Syncro/4motion, VW PASSAT (3B2) 2.3 VR5 Syncro/4motion, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 2.5 TDI, VW PASSAT (3B2) 2.5 TDI Syncro/4motion, VW PASSAT (3B2) 1.9 TDI 4motion, VW PASSAT (3B2) 2.0, VW PASSAT (3B2) 2.0 4motion, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 1.8, VW PASSAT (3B2) 2.8 V6, VW PASSAT (3B2) 2.8 V6 … View more
The steps may slightly vary depending on the car design.
VW PASSAT (3B2) 1.6, VW PASSAT (3B2) 1.8, VW PASSAT (3B2) 1.8 T, VW PASSAT (3B2) 2.3 VR5, VW PASSAT (3B2) 2.8 V6 Syncro/4motion, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 2.8 V6, VW PASSAT (3B2) 1.8 Syncro/4motion, VW PASSAT (3B2) 1.9 TDI Syncro/4motion, VW PASSAT (3B2) 2.3 VR5 Syncro/4motion, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 2.5 TDI, VW PASSAT (3B2) 2.5 TDI Syncro/4motion, VW PASSAT (3B2) 1.9 TDI 4motion, VW PASSAT (3B2) 2.0, VW PASSAT (3B2) 2.0 4motion, VW PASSAT (3B2) 1.9 TDI, VW PASSAT (3B2) 1.8, VW PASSAT (3B2) 2.8 V6, VW PASSAT (3B2) 2.8 V6 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Discs for PASSAT (3B2) and other VW models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Drive socket # 21
Combination spanner #13
Combination spanner #15
Wheel impact socket #17
Brake caliper wind back tool
Ratchet wrench
Torque wrench
Tap wrench
Crow bar
Wheel chock
Replacement: brake discs – VW PASSAT (3B2). AUTODOC experts recommend:
- Replace the brake disks on the car VW PASSAT (3B2) in complete set for each axis. Regardless of the state of components. This will ensure even braking.
- The replacement procedure is identical for both brake disks on the same axle.
- When changing the brake discs, always replace the brake pads.
- Please note: all work on the car – VW PASSAT (3B2) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Open the bonnet. Unscrew the brake fluid reservoir cap. - Step 2
Secure the wheels with chocks. - Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 4Raise the front of the car and secure on supports.Step 5
Unscrew the wheel bolts.Replacement: brake discs – VW PASSAT (3B2). AUTODOC recommends:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 6
Remove the wheel. - Step 7
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray. - Step 8
Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #15. - Step 9
Disconnect the brake pads wear sensor. Use a crowbar.Please note!Some cars are not equipped with the brake pad wear sensor. - Step 10
Spread the brake pads. Use a crowbar. - Step 11
Remove the brake caliper.Replacement: brake discs – VW PASSAT (3B2). Tip from AUTODOC experts:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary. - Step 12
Remove the brake pads. - Step 13
Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray. - Step 14
Unscrew the caliper bracket fastening. Use a drive socket #21. Use a ratchet wrench. Use a tap wrench. - Step 15
Remove the caliper bracket. - Step 16
Remove the retaining ring. Use a crowbar. - Step 17
Remove the brake disc. - Step 18
Clean the hub. Use a wire brush. Treat the contacting surface. Use copper grease. - Step 19
Install the brake disc. - Step 20
Install the retaining ring.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Passat B5 Saloon (3B2) model
Popular maintenance tutorials for Passat 3b2
Complete guides for changing the Brake rotors on different VW PASSAT models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW PASSAT (3B2)
View more
Don’t Replace, Restore: Fixing Damaged Threads at Home
Top 5 mistakes when replacing spark plugs | AUTODOC tips
Which Coolant is Best? Comparison Test | AUTODOC
How to Polish Your Car Yourself and Save Money on Garage Services | AUTODOC tips
Most commonly replaced car parts on VW PASSAT
Time to replace parts? Get even better deals in our Shop app.

SCAN ME

































