Disclaimer
How to change front brake discs on Mercedes W210 – replacement guide
downloads:
7
Views:
55
Recommended replacement interval for the part category Brake disc : 50000 km
Important!
This replacement procedure can be used for:
MERCEDES-BENZ E-Class Saloon (W210) E 320 (210.055), MERCEDES-BENZ E-Class Saloon (W210) E 280 (210.053), MERCEDES-BENZ E-Class Saloon (W210) E 420 (210.072), MERCEDES-BENZ E-Class Saloon (W210) E 270 CDI (210.016), MERCEDES-BENZ E-Class Saloon (W210) E 280 (210.063), MERCEDES-BENZ E-Class Saloon (W210) E 280 4-matic (210.081), MERCEDES-BENZ E-Class Saloon (W210) E 320 (210.065), MERCEDES-BENZ E-Class Saloon (W210) E 300 Turbo-D (210.025), MERCEDES-BENZ E-Class Saloon (W210) E 320 4-matic (210.082), MERCEDES-BENZ E-Class Saloon (W210) E 240 (210.061), MERCEDES-BENZ E-Class Saloon (W210) E 200 Kompressor (210.045), MERCEDES-BENZ E-Class Saloon (W210) E 270 CDI (210.016), MERCEDES-BENZ E-Class Saloon (W210) E 320 CDI (210.026) … View more
The steps may slightly vary depending on the car design.
MERCEDES-BENZ E-Class Saloon (W210) E 320 (210.055), MERCEDES-BENZ E-Class Saloon (W210) E 280 (210.053), MERCEDES-BENZ E-Class Saloon (W210) E 420 (210.072), MERCEDES-BENZ E-Class Saloon (W210) E 270 CDI (210.016), MERCEDES-BENZ E-Class Saloon (W210) E 280 (210.063), MERCEDES-BENZ E-Class Saloon (W210) E 280 4-matic (210.081), MERCEDES-BENZ E-Class Saloon (W210) E 320 (210.065), MERCEDES-BENZ E-Class Saloon (W210) E 300 Turbo-D (210.025), MERCEDES-BENZ E-Class Saloon (W210) E 320 4-matic (210.082), MERCEDES-BENZ E-Class Saloon (W210) E 240 (210.061), MERCEDES-BENZ E-Class Saloon (W210) E 200 Kompressor (210.045), MERCEDES-BENZ E-Class Saloon (W210) E 270 CDI (210.016), MERCEDES-BENZ E-Class Saloon (W210) E 320 CDI (210.026) … View more
The steps may slightly vary depending on the car design.
How to change front brake disc and pads set on MERCEDES W210 [TUTORIAL AUTODOC]

All the parts you need to replace – Brake Discs for E-Class Saloon (W210) and other MERCEDES-BENZ models
Alternative products

Wire brush
Nylon cleaning brush
WD-40 spray
Brake cleaner
Anti-squeal paste
Ceramic grease
Torque wrench
Drive socket # 18
HEX bit No.H5
HEX bit No.H7
Wheel impact socket #17
Ratchet wrench
Crow bar
Tap wrench
Brake caliper wind back tool
Long nose pliers
Wheel chock
AUTODOC recommends:
- Replace the brake disks on the car Mercedes W210 in complete set for each axis. Regardless of the state of components. This will ensure even braking.
- The replacement procedure is identical for both brake disks on the same axle.
- When changing the brake discs, always replace the brake pads.
- Please note: all work on the car – Mercedes W210 – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Open the bonnet. - Step 2
Unscrew the brake fluid reservoir cap. - Step 3Secure the wheels with chocks.Step 4
Loosen the wheel bolts. Use wheel impact socket #17. Use a tap wrench. - Step 5
Raise the car.Replacement: brake discs – Mercedes W210. AUTODOC recommends:If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands. - Step 6
Unscrew the wheel bolts.AUTODOC recommends:Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. Mercedes W210 - Step 7
Remove the wheel. - Step 8
Detach the brake caliper retaining spring. Use a crowbar. - Step 9
Disconnect the brake pad wear sensor. Use long nose pliers. - Step 10
Spread the brake pads. Use a crowbar. - Step 11
Remove the caps from the brake caliper guide pin boots. Use a crowbar. - Step 12
Unscrew the brake caliper fasteners. Use HEX No.H7. Use a ratchet wrench. - Step 13
Remove the brake caliper.AUTODOC recommends:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 14
Remove the brake pads. - Step 15
Clean the brake caliper bracket fasteners. Use a wire brush. Use WD-40 spray. - Step 16
Unscrew the brake caliper bracket fasteners. Use a drive socket #18. Use a ratchet wrench. - Step 17
Remove the fastening bolts. - Step 18
Remove the brake caliper bracket. - Step 19
Clean the brake disc fastener. Use a wire brush. Use WD-40 spray. - Step 20
Unscrew the brake disc fasteners. Use HEX No.H5. Use a ratchet wrench. - Step 21Remove the fastening bolt.Step 22
Remove the brake disc. - Step 23
Clean the wheel hub. Use a wire brush. - Step 24Treat the contacting surface. Use ceramic grease.Step 25
Install a new brake disc. - Step 26
Install the fastening bolt. - Step 27
Tighten the brake disc fasteners. Use HEX No.H5. Use a torque wrench. Tighten it to 10 Nm torque. - Step 28
Clean the brake caliper bracket of dirt and dust. Use a wire brush. Use a brake cleaner.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the MERCEDES-BENZ E-Class Saloon (W210) model
Popular maintenance tutorials for W210
Complete guides for changing the Brake rotors on different MERCEDES-BENZ E-CLASS models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your MERCEDES-BENZ E-Class Saloon (W210)
View more
BMW E30 Turbo Suspension Swap: Boost Your Handling | AUTODOC project
How to restore a steering wheel | AUTODOC tips
Top 7 Manual Transmission Mistakes to Avoid | AUTODOC Tips
Revive Your Tyres: Expert Tips for a Lasting Shine | AUTODOC Guide
Most commonly replaced car parts on MERCEDES-BENZ E-CLASS
Time to replace parts? Get even better deals in our Shop app.

SCAN ME







































