Disclaimer
How to change front brake caliper on NISSAN Qashqai II (J11) – replacement guide
downloads:
19
Views:
294
Recommended replacement interval for the part category Brake caliper : 100000 km
Important!
This replacement procedure can be used for:
NISSAN Qashqai II (J11, J11_) 1.7 dCi ALL MODE 4x4-i … View more
The steps may slightly vary depending on the car design.
NISSAN Qashqai II (J11, J11_) 1.7 dCi ALL MODE 4x4-i … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Calipers for Qashqai II (J11, J11_) and other NISSAN models
Alternative products

Wire brush
Brake cleaner
Copper grease
Combination spanner №12
Combination spanner №14
Drive socket # 12
Drive socket # 14
Wheel impact socket #21
Ratchet wrench
Torque wrench
Hammer
Crow bar
Fluid container
Brake hose clip
Wheel chock
Replacement: brake caliper – NISSAN QASHQAI (J11, J11_). Tip from AUTODOC:
- The replacement procedure is identical for the left and right brake calipers on the same axle.
- Warning! Shut down the engine before starting any work – NISSAN QASHQAI (J11, J11_)
Carry out replacement in the following order:
- Step 1Open the bonnet.Step 2
Unscrew the brake fluid reservoir cap. - Step 3
Secure the wheels with chocks. - Step 4
Loosen the wheel mounting bolts. Use wheel impact socket #21. - Step 5Raise the front of the car and secure on supports.Step 6
Unscrew the wheel bolts.AUTODOC recommends:Important! Hold the wheel while unscrewing the fastening bolts. NISSAN QASHQAI (J11, J11_) - Step 7
Remove the wheel. - Step 8
Remove the fastener attaching the brake hose to the shock strut. Use a crowbar. Use a hammer. - Step 9
Detach the brake hose from the shock strut. - Step 10
Clean the area where the brake hose is connected to the caliper, and the guide pins area. Use a wire brush. Use a brake cleaner.Replacement: brake caliper – NISSAN QASHQAI (J11, J11_). Tip from AUTODOC:After applying the spray, wait a few minutes. - Step 11
Put a container for gathering brake fluid beneath. - Step 12
Clamp the brake hose off using a brake hose clamp. - Step 13
Unscrew the brake hose from the brake caliper. Use a drive socket #12. Use a ratchet wrench. - Step 14
Spread the brake pads. Use a crowbar. - Step 15
Unscrew the brake caliper fastening. Use a drive socket #14. Use a ratchet wrench. - Step 16
Remove the brake caliper.AUTODOC recommends:When replacing the brake caliper, it is recommended to check the brake hose for damages and, if necessary, to replace it with a new one. When replacing a brake caliper it is recommended to replace brake pads, check the state of the brake discs and replace them with new ones if necessary. - Step 17
Clean the brake caliper bracket from dirt and dust. Use a wire brush. Treat the brake caliper bracket. Use a brake cleaner.Replacement: brake caliper – NISSAN QASHQAI (J11, J11_). Tip:After applying the spray, wait a few minutes.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the NISSAN Qashqai II (J11) model
Popular maintenance tutorials for Nissan Qashqai J11
Complete guides for changing the Brake calipers on different NISSAN QASHQAI models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your NISSAN Qashqai II (J11, J11_)
View more
How to Use Sandblasting Equipment: Step-by-Step Guide | AUTODOC Tips
DIY brake caliper restoration | AUTODOC tips
Top 7 Manual Transmission Mistakes to Avoid | AUTODOC Tips
Discover the 4 Key Reasons Your CHECK ENGINE Light Could Be On | AUTODOC Tips
Most commonly replaced car parts on NISSAN QASHQAI
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




























