Important!
This replacement procedure can be used for:
SKODA Karoq Off-Road (NU7) 1.0 TSI, SKODA Karoq Off-Road (NU7) 1.5 TSI, SKODA Karoq Off-Road (NU7) 1.6 TDI, SKODA Karoq Off-Road (NU7) 2.0 TDI 4x4, SKODA Karoq Off-Road (NU7) 2.0 TDI 4x4 (DFHA), SKODA Karoq Off-Road (NU7) 1.5 TSI 4x4, SKODA Karoq Off-Road (NU7) 2.0 TDI 4x4, SKODA Karoq Off-Road (NU7) 2.0 TDI, SKODA Karoq Off-Road (NU7) 2.0 TSI 4x4, SKODA Karoq Off-Road (NU7) 1.6 SRE, SKODA Karoq Off-Road (NU7) 1.4 TSI, SKODA Karoq Off-Road (NU7) 1.0 TSI, SKODA Karoq Off-Road (NU7) 2.0 TDI, SKODA Karoq Off-Road (NU7) 2.0 TDI 4x4, SKODA Karoq Off-Road (NU7) 1.4 TSI 4x4 View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Anti Roll Bar Links for Karoq Off-Road (NU7) and other SKODA models
Tools
Replacement: anti roll bar links – SKODA KAROQ (NU7). List of the tools you'll need:
Wire brush
WD-40 spray
Brake cleaner
Ceramic grease
Copper grease
Torque wrench
Combination spanner #18
Combination spanner #19
Drive socket # 18
Drive socket # 19
XZN socket bit #6
HEX bit No.H5
Wheel impact socket #17
Ratchet wrench
Wheel chock
AUTODOC recommends:
  • Replace the stabiliser links on SKODA KAROQ (NU7) in pairs.
  • The replacement procedure is identical for both stabiliser links on the same axle.
  • Please note: all work on the car – SKODA KAROQ (NU7) – should be done with the engine switched off.
Carry out replacement in the following order:
  1. Step 1
    Secure the wheels with chocks.
    Step 2
    How to change Anti Roll Bar Links on Skoda Karoq NU 2017 - free PDF and video manuals
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  2. Step 3
    Raise the car.
    Replacement: anti roll bar links – SKODA KAROQ (NU7). Professionals recommend:
    If you are using a jack, make sure it rests on a flat surface without any unevenness.Be sure to additionally secure the car with jack stands.
    Step 4
    How to replace SKODA Karoq Off-Road (NU7) 1.5 TSI 2018 Anti Roll Bar Links - step-by-step manuals and video guides
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. SKODA KAROQ (NU7)
  3. Step 5
    Skoda Karoq NU 2.0 TDI 4x4 (DFFA) 2019 Anti Roll Bar Links replacement: free workshop manuals
    Remove the wheel.
  4. Step 6
    Changing Anti Roll Bar Links on SKODA Karoq Off-Road (NU7) 1.6 TDI 2020 by yourself
    Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
  5. Step 7
    How to remove SKODA KAROQ 1.5 TSI 4x4 2021 Anti Roll Bar Links - online easy-to-follow instructions
    Unscrew the fastener connecting the stabilizer link to the shock strut. Use a drive socket #18. Use XZN #6. Use a ratchet wrench.
  6. Step 8
    How to replace Anti Roll Bar Links on SKODA Karoq Off-Road (NU7) 2022: download PDF manuals and video instructions
    Unscrew the fastener connecting the stabilizer link to the stabilizer bar. Use a combination spanner #18. Use XZN #6. Use a ratchet wrench.
  7. Step 9
    How hard is it to do yourself: Anti Roll Bar Links replacement on Skoda Karoq NU 2.0 TDI 2023 - download illustrated guide
    Remove the stabiliser link.
    Replacement: anti roll bar links – SKODA KAROQ (NU7). Tip from AUTODOC experts:
    Examine stabiliser bushes. Replace them if needed.
  8. Step 10
    Need to know how to renew Anti Roll Bar Links on SKODA KAROQ 2024? This free workshop manual will help you to do it yourself
    Clean the mounting seats of the stabiliser link. Use a wire brush. Use WD-40 spray.
  9. Step 11
    Changing of Anti Roll Bar Links on Skoda Karoq NU 2017 won't be an issue if you follow this illustrated step-by-step guide
    Install a new stabiliser link and tighten the fasteners. Use a combination spanner #19. Use HEX No.H5. Use a ratchet wrench.
  10. Step 12
    SKODA KAROQ 2.0 TSI 4x4 Anti Roll Bar Links replacement: online guides and video tutorials
    Tighten the fastener connecting the stabilizer link to the shock strut. Use a drive socket #19. Use a torque wrench. Tighten it to 65 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the SKODA Karoq Off-Road (NU7) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
SKODA Karoq Off-Road (NU7) Anti Roll Bar Links replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY SKODA Karoq Off-Road (NU7) Anti Roll Bar Links replacement - online guide
Tips & tricks for your SKODA Karoq Off-Road (NU7)
View more
  • How to change Drop links on SKODA Karoq Off-Road (NU7) 1.0 TSI - replacement tricks
    How to replace a wheel stud | AUTODOC tips
  • Changing Stabilizer link Skoda Karoq NU 1.5 TSI - Replacement Tips
    Top 5 reasons why your car squeals | AUTODOC Tips
  • Maintenance Hacks - SKODA Karoq Off-Road (NU7) 2.0 TDI 4x4 (DFFA) Sway bar link replacement guide
    DIY valve cover restoration | AUTODOC tips
  • Replace Drop link on Skoda Karoq NU - free video tips
    How to prevent car windows from fogging up | AUTODOC tips