Important!

This replacement procedure can be used for:
SKODA SUPERB (3U4) 1.8 T, SKODA SUPERB (3U4) 2.0, SKODA SUPERB (3U4) 2.8 V6, SKODA SUPERB (3U4) 1.9 TDI, SKODA SUPERB (3U4) 2.5 TDI, SKODA SUPERB (3U4) 1.9 TDI, SKODA SUPERB (3U4) 2.5 TDI, SKODA SUPERB (3U4) 2.0 TDI, SKODA SUPERB (3U4) 1.9 TDI, SKODA SUPERB (3U4) 1.9 TDI, SKODA SUPERB (3U4) 2.8 V6, SKODA SUPERB (3U4) 2.0 TDI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Anti-roll bar link

Replacement: anti roll bar links – SKODA SUPERB (3U4). Tools you might need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner 
                    
                      Copper grease 
                    
                      Combination spanner #16
                    
                      Drive socket # 16 
                    
                      Wheel impact socket #17
                    
                      Torque wrench
                    
                      Wheel chock

Buy tools

Replacement: anti roll bar links – SKODA SUPERB (3U4). Tip from AUTODOC:

Replace the stabiliser links on SKODA SUPERB (3U4) in pairs.
The replacement procedure is identical for both stabiliser links on the same axle.
All work should be done with the engine stopped.

Replacement: anti roll bar links – SKODA SUPERB (3U4). Use the following procedure:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

Replacement: anti roll bar links – SKODA SUPERB (3U4). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 5

Remove the wheel.
Step 6

Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
Step 7

Unscrew the fastener connecting the stabilizer link to the stabilizer bar. Use a combination spanner #16 (2 pieces).
Step 8

Unscrew the fastener connecting the stabilizer bar with the control arm. Use a combination spanner #16 (2 pieces).
Step 9

Remove the stabilizer rod.

Replacement: anti roll bar links – SKODA SUPERB (3U4). AUTODOC experts recommend:
Examine stabiliser bushes. Replace them if needed.
Step 10

Clean the mounting seats of the stabiliser link. Use a wire brush. Use WD-40 spray.
Step 11

Install a new rod, tighten the fasteners.
Step 12

Tighten the fastener connecting the stabilizer link to the stabilizer bar. Use a combination spanner #16. Use a drive socket #16. Use a torque wrench. Tighten it to 40 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 13

Tighten the fastener connecting the stabilizer bar with the control arm. Use a combination spanner #16. Use a drive socket #16. Use a torque wrench. Tighten it to 40 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 14

Treat all joints of the stabiliser link. Use copper grease.
Step 15

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 16

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: anti roll bar links – SKODA SUPERB (3U4). After applying the spray, wait a few minutes.
Step 17

Install the wheel.

Replacement: anti roll bar links – SKODA SUPERB (3U4). AUTODOC experts recommend:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 18

Screw in the wheel bolts. Use wheel impact socket #17.
Step 19

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 120 nm torque.
Step 20

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the SKODA Superb I Saloon (3U4) model

Skoda Superb 3u tyre size

How to change track rod end on SKODA SUPERB (3U4) – replacement guide

Free download PDF
1.39 MB
How to change front wheel bearing on SKODA SUPERB (3U4) – replacement guide

Free download PDF
3.96 MB
How to change rear wheel bearing on SKODA SUPERB (3U4) – replacement guide

Free download PDF
2.28 MB
How to change front lower arm on SKODA SUPERB (3U4) – replacement guide

Free download PDF
2.03 MB
How to change front strut mount on SKODA SUPERB (3U4) – replacement guide

Free download PDF
1.84 MB
How to change rear strut mount on SKODA SUPERB (3U4) – replacement guide

Free download PDF
1.56 MB

How to change front anti roll bar links on SKODA SUPERB Estate (3V5) – replacement guide

Free download PDF
1.15 MB
How to change front anti roll bar links on SKODA SUPERB (3V3) – replacement guide

Free download PDF
1.15 MB
How to change front anti roll bar links on SKODA Superb II Estate (3T5) – replacement guide

Free download PDF
1.31 MB
How to change rear anti roll bar links on SKODA SUPERB Estate (3T5) – replacement guide

Free download PDF
1.42 MB
How to change front anti roll bar links on SKODA Superb II Hatchback (3T4) – replacement guide

Free download PDF
1.3 MB
How to change rear anti roll bar links on SKODA SUPERB (3T4) – replacement guide

Free download PDF
1.41 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

DIY car soundproofing | AUTODOC tips

107K views

Published on: 15/04/2021
DIY rear axle restoration | Drivetrain restoration – Part 2

7K views

Published on: 07/11/2024
Stop Rust Before It Starts: Top 5 Tips for Car Body Protection | AUTODOC Insights

7K views

Published on: 27/07/2023
#TPMS Explained: Why Your Light is On and How to Respond Safely

9K views

Published on: 28/09/2023