
Disclaimer
How to change front anti roll bar links on ALPINA D10 (E39) – replacement guide
downloads:
0
Views:
3
Important!
This replacement procedure can be used for:
ALPINA D10 (E39) 3.0 D Biturbo … View more
The steps may slightly vary depending on the car design.
ALPINA D10 (E39) 3.0 D Biturbo … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Anti Roll Bar Links for D10 (E39) and other ALPINA models
Anti-roll bar link
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Copper grease
Combination spanner #17
Drive socket # 17
Wheel impact socket #17
Ratchet wrench
Torque wrench
Wheel chock
Replacement: anti roll bar links – ALPINA D10 (E39). AUTODOC experts recommend:
- Replace the stabiliser links on ALPINA D10 (E39) in pairs.
- The replacement procedure is identical for both stabiliser links on the same axle.
- All work should be done with the engine stopped.
Replacement: anti roll bar links – ALPINA D10 (E39). Take the following steps:
- Step 1Secure the wheels with chocks.
- Step 2Loosen the wheel mounting bolts. Use wheel impact socket #17.
- Step 3Raise the front of the car and secure on supports.Step 4Unscrew the wheel bolts.Replacement: anti roll bar links – ALPINA D10 (E39). Tip:To avoid injury, hold up the wheel when unscrewing the bolts.
- Step 5Remove the wheel.
- Step 6Clean the stabiliser link fasteners. Use a wire brush. Use WD-40 spray.
- Step 7Unscrew the fastener connecting the stabilizer link to the stabilizer bar. Use a drive socket #17. Use a ratchet wrench.
- Step 8Unscrew the fastener connecting the stabilizer link to the shock strut. Use a combination spanner #17. Use a drive socket #17. Use a ratchet wrench.
- Step 9Remove the stabilizer rod.Replacement: anti roll bar links – ALPINA D10 (E39). AUTODOC recommends:Examine stabiliser bushes. Replace them if needed.
- Step 10Clean the mounting seats of the stabiliser link. Use a wire brush. Use WD-40 spray.
- Step 11Ιnstall the transverse stabilizer link.
- Step 12Tighten the stabiliser link fastener. Use a combination spanner #17. Use a drive socket #17. Use a ratchet wrench.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the ALPINA D10 Saloon (E39) model
Popular maintenance tutorials for ALPINA D10 (E39)
Complete guides for changing the Drop links on different ALPINA D10 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your ALPINA D10 (E39)
View more
- DIY brake caliper restoration | AUTODOC tips
- Stop Rust Before It Starts: Top 5 Tips for Car Body Protection | AUTODOC Insights
- TOP 5 mistakes when replacing shock absorbers | AUTODOC tips
- How to tighten cylinder head bolts
Most commonly replaced car parts on ALPINA D10
Time to replace parts? Get even better deals in our Shop app.

SCAN ME