Recommended replacement interval for the part category Engine thermostat : 50000 km

Important!

This replacement procedure can be used for:
SEAT Ibiza II (6K1) 1.6 i, SEAT Ibiza II (6K1) 1.8 T 20V Cupra … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Thermostat for Ibiza II (6K1) and other SEAT models

Engine thermostat

Engine thermostat for Ibiza II (6K1) Petrol (101 hp)

Simple DIY car repair steps – Replacing Engine thermostat on Ibiza II (6K1)

Engine thermostat for Ibiza II (6K1) Petrol (156 hp)

Replacement: engine thermostat – SEAT IBIZA II (6K1). Tools you might need:

                        Wire brush
                      
                        All-purpose cleaning spray
                      
                        Electronic spray
                      
                        Sealant
                      
                        Torque wrench
                      
                        Combination spanner #10
                      
                        Combination spanner #13
                      
                        Combination spanner #17
                      
                        Combination spanner #46
                      
                        Drive socket # 10
                      
                        Drive socket # 13
                      
                        HEX bit No.H5
                      
                        HEX bit No.H8
                      
                        Ratchet wrench
                      
                        Funnel
                      
                        Fluid container
                      
                        Pincers
                      
                        Fender cover

Buy tools

Replacement: engine thermostat – SEAT IBIZA II (6K1). AUTODOC experts recommend:

Check the condition of the coolant every time you replace the thermostat. Change the coolant if necessary.
All work should be done with the engine stopped.

Carry out replacement in the following order:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the engine cover fastener. Use HEX No.H5. Use a ratchet wrench.
Step 4

Remove the engine cover.

AUTODOC recommends:
Replacement: engine thermostat – SEAT IBIZA II (6K1). Do not use excessive force when removing the part as this may damage it.
Step 5

Unscrew the coolant reservoir cap.
Step 6

Prepare a container for fluids.
Step 7

Clean the coolant hose. Use all-purpose cleaning spray.
Step 8

Disconnect the coolant pipe retaining clip.
Step 9

Detach the coolant hose.

Replacement: engine thermostat – SEAT IBIZA II (6K1). Professionals recommend:
Caution! Coolant may leak out of the coolant lines and thermostat housing.
Step 10

Drain the coolant from the engine.

Replacement: engine thermostat – SEAT IBIZA II (6K1). Tip:
Caution! The coolant can be very hot.Wear gloves to prevent contact with hot liquid.All work should be done with the engine stopped.Wait until the coolant has completely flowed out of the drain hole.
Step 11

Clean the coolant hose. Use all-purpose cleaning spray.
Step 12

Attach the coolant hose.
Step 13

Connect the coolant pipe retaining clip.

Step 14

Clean the coolant hose. Use all-purpose cleaning spray.
Step 15

Pull aside the V-ribbed belt tensioner pulley. Use a combination spanner #17.
Step 16

Remove the V-ribbed belt.

Replacement: engine thermostat – SEAT IBIZA II (6K1). Tip from AUTODOC:
Check the condition of the tensioner pulley and idler pulley. Replace them if necessary.
Step 17

Return the tensioner pulley to its initial position.
Step 18

Remove the battery cover.
Step 19

Unscrew the fasteners of the car battery terminals. Use a combination spanner #10.
Step 20

Remove the battery terminals.
Step 21

Loosen the alternator fasteners. Use HEX No.H8.
Step 22

Unscrew the fastener of the viscous fan clutch. Use a combination spanner #46. Use HEX No.H8.
Step 23

Loosen the alternator fasteners. Use HEX No.H8.
Step 24

Remove the alternator.
Step 25

Disconnect the alternator connector.
Step 26

Unscrew the alternator power cable fastener. Use a combination spanner #13.
Step 27

Clean the thermostat housing. Use all-purpose cleaning spray.
Step 28

Unscrew the thermostat housing fasteners. Use a drive socket #10. Use a ratchet wrench.
Step 29

Remove the thermostat housing.

AUTODOC recommends:
Replacement: engine thermostat – SEAT IBIZA II (6K1). Do not use excessive force when removing the part as this may damage it.
Step 30

Remove the thermostat. Use pincers.

Replacement: engine thermostat – SEAT IBIZA II (6K1). Tip:
Do not apply excessive force when removing the part. Otherwise you may damage it.Caution! Coolant may leak out of the coolant lines and thermostat housing.
Step 31

Clean the thermostat housing mounting seat. Use a wire brush. Use all-purpose cleaning spray.
Step 32

Install a new thermostat.

AUTODOC recommends:
Replacement: engine thermostat – SEAT IBIZA II (6K1). Do not use excessive force during installation. This may damage the part.
Step 33

Treat the thermostat housing. Use a sealant.
Step 34

Install the thermostat housing.

Replacement: engine thermostat – SEAT IBIZA II (6K1). Tip from AUTODOC:
When installing, do not use excessive force to avoid damage to the part.
Step 35

Tighten the thermostat housing fasteners. Use a drive socket #10. Use a torque wrench. Tighten it to 6 nm torque.
Step 36

Tighten the alternator power cable fastener. Use a drive socket #13. Use a torque wrench. Tighten it to 5 nm torque.
Step 37

Connect the alternator connector.
Step 38

Install the alternator.
Step 39

Tighten the alternator fasteners. Use HEX No.H8. Use a torque wrench. Tighten it to 8 nm torque.
Step 40

Tighten the fastener of the viscous fan clutch. Use a combination spanner #46. Use HEX No.H8. Use a torque wrench. Tighten it to 24 nm torque.
Step 41

Pull aside the V-ribbed belt tensioner pulley. Use a combination spanner #17.
Step 42

Install the V-ribbed belt.

Replacement: engine thermostat – SEAT IBIZA II (6K1). AUTODOC experts recommend:
Check the condition of the tensioner pulley and idler pulley. Replace them if necessary.
Step 43

Return the tensioner pulley to its initial position.
Step 44

Remove the coolant reservoir cap.
Step 45

Insert the funnel.
Step 46

Pour coolant in the coolant reservoir.

Replacement: engine thermostat – SEAT IBIZA II (6K1). AUTODOC recommends:
Only use the coolant recommended by the manufacturer.The coolant level should be at the MAX mark.Wait until the air goes out of the system.
Step 47

Attach the terminals to the battery.

Replacement: engine thermostat – SEAT IBIZA II (6K1). Tip from AUTODOC:
Be careful! Do not mix up the positive and the negative terminals of the car battery.
Step 48

Screw in the fasteners of the battery terminals. Use a combination spanner #10.
Step 49

Treat the battery terminals. Use dielectric grease.
Step 50

Install the battery cover.
Step 51

Run the engine for a few minutes. This should be done in order to remove residual air from the cooling system and to check if the components are operating correctly.

Step 52

Shut off the engine.

Step 53

Install the coolant reservoir cap.
Step 54

Screw on the coolant reservoir cap.
Step 55

Install the engine cover and secure it.

AUTODOC recommends:
Replacement: engine thermostat – SEAT IBIZA II (6K1). Do not use excessive force during installation. This may damage the part.
Step 56

Screw in the engine cover fasteners. Use HEX No.H5. Use a ratchet wrench.

Step 57

Check the coolant level. If necessary, top up to the required level.

Step 58

Remove the fender protection cover.

Step 59

Close the hood.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the SEAT Ibiza II (6K1) model.

Browse tyres

How to change distributor cap on SEAT Ibiza II (6K1) – replacement guide

Free download PDF
737.28 KB
How to change coolant flange on SEAT Ibiza II (6K1) – replacement guide

Free download PDF
1.18 MB
How to change ignition coil on SEAT Ibiza II (6K1) – replacement guide

Free download PDF
1.77 MB
How to change spark plugs on SEAT Ibiza II (6K1) – replacement guide

Free download PDF
1.77 MB
How to change water pump on SEAT Ibiza II (6K1) – replacement guide

Free download PDF
2.46 MB
How to change ignition leads on SEAT Ibiza II (6K1) – replacement guide

Free download PDF
1.21 MB

How to change engine thermostat on SEAT Ibiza IV Hatchback (6J5, 6P1) – replacement guide

Free download PDF
2.71 MB
How to change engine thermostat on SEAT Ibiza III Hatchback (6L) – replacement guide

Free download PDF
2.77 MB
How to change engine thermostat on SEAT Ibiza IV Sportcoupe (6J, 6P) – replacement guide

Free download PDF
2.71 MB
How to change engine thermostat on SEAT IBIZA I (021A) – replacement guide

Free download PDF
1.21 MB
How to change engine thermostat on SEAT AROSA (6H) – replacement guide

Free download PDF
1.2 MB
How to change engine thermostat on SEAT TOLEDO I (1L) – replacement guide

Free download PDF
1.22 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

How to polish an old engine valve cover to a shiny finish | AUTODOC Tips

8K views

Published on: 30/11/2023
How to check your head gasket | AUTODOC

4K views

Published on: 03/12/2020
What to do if your car heater isn't working | AUTODOC tips

4K views

Published on: 11/02/2021
Petrol or diesel? What's the difference between these engines? | AUTODOC

4K views

Published on: 04/05/2021