Disclaimer
How to change engine oil and filter on VW Polo II Hatchback (86C, 80) – replacement guide
downloads:
4
Views:
50
Recommended replacement interval for the part category Oil filter : 1 year / 7500 km
Important!
This replacement procedure can be used for:
VW Polo Hatchback (86C, 80) 1.3, VW Polo Hatchback (86C, 80) 1.0, VW Polo Hatchback (86C, 80) 1.0 Cat, VW Polo Hatchback (86C, 80) 1.3 Cat … View more
The steps may slightly vary depending on the car design.
VW Polo Hatchback (86C, 80) 1.3, VW Polo Hatchback (86C, 80) 1.0, VW Polo Hatchback (86C, 80) 1.0 Cat, VW Polo Hatchback (86C, 80) 1.3 Cat … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for Polo Hatchback (86C, 80) and other VW models
Alternative products

Torx bit T25
Drive socket # 19
Drive socket # 30
Combination spanner #30
Torque wrench
Oil drain pan
Funnel
Replacement: engine oil and filter – VW POLO (86C, 80). Tip from AUTODOC:
- Replace the oil filter every time when changing motor oil.
- All work should be done with the engine stopped.
- Wear gloves to prevent contact with hot liquid.
Replacement: engine oil and filter – VW POLO (86C, 80). Take the following steps:
- Step 1Open the hood.Step 2Lift the car using a jack or place it over an inspection pit.AUTODOC recommends:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.Step 3
Undo the fasteners of the oil pan lower cover. Use Torx T25. - Step 4
Put a waste oil container with at least 4 l capacity under the drainage hole. - Step 5
Unscrew the drain plug. Use a drive socket No.19 or ring spanner No.19. Drain the used oil.Replacement: engine oil and filter – VW POLO (86C, 80). AUTODOC recommends:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 6
Move the container under the oil filter. - Step 7
Unscrew the oil filter. Use a combination spanner #30. - Step 8
Prepare a container for the old oil filter. Put the old oil filter in the container.Replacement: engine oil and filter – VW POLO (86C, 80). Tip from AUTODOC:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter. - Step 9
Clean the oil filter seat.AUTODOC recommends:Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 10
Screw the new filter into its place. Use a drive socket #18. Use a torque wrench. Tighten it to 20 Nm torque. - Step 11
Clean the area of the oil pan drainage hole.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW Polo II Hatchback (86C, 80) model
Popular maintenance tutorials for VW Polo 86c
Complete guides for changing the Oil filters on different VW POLO models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW Polo Hatchback (86C, 80)
View more
Top 5 Car Interior Cleaning Mistakes You Should Avoid | AUTODOC Tips
How to tell if a tie rod is faulty
Stop Rust Before It Starts: Top 5 Tips for Car Body Protection | AUTODOC Insights
5 reasons why your car is making a knocking sound
Most commonly replaced car parts on VW POLO
Time to replace parts? Get even better deals in our Shop app.

SCAN ME






























