Recommended replacement interval for the part category Oil filter : 12 month / 15000 km

Important!

This replacement procedure can be used for:
VAUXHALL Agila Mk I (A) (H00) 1.2 16V Twinport, VAUXHALL Agila Mk I (A) (H00) 1.0 12V, VAUXHALL Agila Mk I (A) (H00) 1.2 16V, VAUXHALL Agila Mk I (A) (H00) 1.0 12V … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Oil filter

Replacement: engine oil and filter – VAUXHALL AGILA Mk I (A). List of the tools you'll need:

                      Torx bit T45
                    
                      Drive socket # 12 
                    
                      Drive socket # 32 
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Flat screwdriver
                    
                      Oil drain pan
                    
                      Funnel
                    
                      Microfibre towel
                    
                      Fender cover

Buy tools

Replacement: engine oil and filter – VAUXHALL AGILA Mk I (A). Tip from AUTODOC experts:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
All work should be done with the engine stopped.

Replacement: engine oil and filter – VAUXHALL AGILA Mk I (A). Take the following steps:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the oil filler plug.
Step 4

Pull down the coolant pipe.
Step 5

Clean the oil filter housing cap.
Step 6

Unscrew the filter housing cap together with the old filter element. Use a drive socket #32. Use a ratchet wrench.
Step 7

Prepare a container for the old oil filter.
Step 8

Put the old filter cartridge in the container.
Step 9

Cover the oil filter housing with a microfibre towel to prevent dirt and foreign objects from getting into the system.
Step 10

Undo the fasteners of the oil pan lower cover.
Step 11

Remove the oil pan cover. Use a drive socket #12. Use a ratchet wrench.
Step 12

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – VAUXHALL AGILA Mk I (A). Tip from AUTODOC:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 13

Put a waste oil container with at least 3.5 l capacity under the drainage hole.
Step 14

Unscrew the drain plug. Use Torx T45. Use a ratchet wrench.
Step 15

Drain the used oil.

Replacement: engine oil and filter – VAUXHALL AGILA Mk I (A). Professionals recommend:
Caution! The oil may be hot.
Step 16

Detach the oil filter from the filter cover.
Step 17

Remove the oil filter cover O-ring. Use a flat screwdriver.
Step 18

Install the new oil filter to the mounting seat on the filter cover.

Please note!
Make sure to install the filter correctly. Don't mix up the sides of the part.Wait until the oil has completely drained from the drainage hole.
Step 19

Install a new O-ring to its mounting seat on the filter cover.
Step 20

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 21

Clean the area of the oil pan drainage hole.
Step 22

Screw in the new drainage plug and tighten it. Use Torx T45. Use a torque wrench. Tighten it to 20 Nm torque.
Step 23

Reinstall the oil pan lower cover.
Step 24

Tighten the fasteners of the oil pan lower cover. Use a drive socket #12. Use a ratchet wrench.
Step 25

Lower the car.

Step 26

Remove the microfibre towel from the oil filter housing.
Step 27

Screw the new filter into its place.
Step 28

Screw the cap. Use a drive socket #32. Use a torque wrench. Tighten it to 15 Nm torque.
Step 29

Remove the oil filler cap.
Step 30

Insert the funnel.
Step 31

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – VAUXHALL AGILA Mk I (A). Tip from AUTODOC experts:
Use the oil recommended by the manufacturer.
Step 32

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 33

Tighten the oil filler cap.

Step 34

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.

Step 35

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 36

Install the engine cover and secure it. Make sure you hear a click indicating that it is locked in place.
Step 37

Return the coolant pipe to its initial position.

Step 38

Remove the fender protection cover.

Step 39

Close the hood.

Replacement: engine oil and filter – VAUXHALL AGILA Mk I (A). Tip:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the VAUXHALL Agila Mk1 (A) (H00) model

VAUXHALL AGILA Mk I (A) tyre size

How to change spark plugs on VAUXHALL Agila Mk I (A) (H00) – replacement guide

Free download PDF
1.85 MB
How to change front windshield wipers on VAUXHALL Agila Mk I (A) (H00) – replacement guide

Free download PDF
624.64 KB
How to change ignition coil on VAUXHALL Agila Mk I (A) (H00) – replacement guide

Free download PDF
819.2 KB
How to change manual gearbox oil on VAUXHALL Agila Mk I (A) (H00) – replacement guide

Free download PDF
1.65 MB
How to change rear coil springs on VAUXHALL Zafira Mk II (B) (A05) – replacement guide

Free download PDF
1.44 MB
How to change front coil springs on VAUXHALL Meriva Mk II (B) (S10) – replacement guide

Free download PDF
2.78 MB

How to change engine oil and filter on VAUXHALL Agila Mk II (B) (H08) – replacement guide

Free download PDF
1.36 MB
How to change engine oil and filter on a car – replacement tutorial

Universal

Free download PDF
2.82 MB
How to change engine oil and filter on VAUXHALL Ampera (R12) – replacement guide

Free download PDF
1.56 MB
How to change engine oil and filter on VAUXHALL Astra Mk IV (G) Convertible (T98) – replacement guide

Free download PDF
1.56 MB
How to change engine oil and filter on VAUXHALL Astra Mk3 (F) Convertible (T92) – replacement guide

Free download PDF
1.56 MB
How to change engine oil and filter on VAUXHALL Corsa Mk IV (E) Hatchback (X15) – replacement guide

Free download PDF
1.36 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

How to align the timing marks correctly on an EA888 engine

6K views

Published on: 31/07/2025
Preventing Engine Failure: Head Gasket Inspection Tutorial | AUTODOC

12K views

Published on: 13/10/2020
What to do if your car’s bonnet won’t open | AUTODOC tips

18K views

Published on: 12/09/2024
What to do if your check engine light is on | AUTODOC tips

19K views

Published on: 19/08/2020