How to change engine oil and filter on SKODA Octavia III Combi (5E5) – replacement guide
SKODA Octavia III Combi (5E5) 2.0 TSI RS, SKODA Octavia III Combi (5E5) 2.0 TSI RS, SKODA Octavia III Combi (5E5) 1.8 TSI 4x4, SKODA Octavia III Combi (5E5) 1.8 TSI … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle

- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – SKODA OCTAVIA Combi (5E5) – should be done with the engine switched off.
- Step 1
Open the hood.
Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
Step 3
Clean the cap of the oil filler neck. Use all-purpose cleaning spray.
- Step 4

Clean the oil filter housing cap. Use all-purpose cleaning spray.
- Step 5

Unscrew the oil filler plug.
- Step 6

Pull up the oil dipstick.
- Step 7

Unscrew the filter housing cap together with the old filter element. Use a drive socket #32. Use a ratchet wrench.
- Step 8

Put the old oil filter in the container.
- Step 9
Lift the car using a jack or place it over an inspection pit.
Replacement: engine oil and filter – SKODA OCTAVIA Combi (5E5). Tip from AUTODOC experts:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 10
Put a waste oil container with at least 5 l capacity under the drainage hole.
- Step 11

Clean the area of the oil pan drainage hole. Use a nylon cleaning brush. Use all-purpose cleaning spray.
- Step 12

Unscrew the drain plug. Use a flat screwdriver.
- Step 13

Drain the used oil.
AUTODOC recommends:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
- Step 14

Detach the oil filter from the filter cover.
- Step 15

Remove the oil filter cover O-ring. Use a flat screwdriver.
- Step 16

Clean the oil filter housing cap. Use all-purpose cleaning spray.
- Step 17

Install a new O-ring to its mounting seat on the filter cover.
- Step 18

Install the new oil filter to the mounting seat on the filter cover.
- Step 19

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
- Step 20

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Find out which tyre and wheel sizes are compatible with the SKODA Octavia III Combi (5E5) model
Popular maintenance tutorials for Octavia 5e5
Complete guides for changing the Oil filters on different SKODA OCTAVIA models
Track expenses, manage logs, schedule replacements, and more.
#DIY Wheel Rim Restoration: Revive Scratches and Chips Easily!
Myths about engine oils that need to be debunked
Top 5 reasons why your car squeals | AUTODOC Tips
How to Fix a Squealing Belt: Causes & Solutions | AUTODOC Expert Tips
Most commonly replaced car parts on SKODA OCTAVIA































