Disclaimer
How to change engine oil and filter on RENAULT Megane I Hatchback (BA) – replacement guide
downloads:
2
Views:
145
Recommended replacement interval for the part category Oil filter : 1 year / 20000 km
Important!
This replacement procedure can be used for:
RENAULT MEGANE I (BA0/1_) 1.4 e (BA0E, BA0V), RENAULT MEGANE I (BA0/1_) 1.6 e (BA0F, BA0S), RENAULT MEGANE I (BA0/1_) 2.0 i (BA0G), RENAULT MEGANE I (BA0/1_) 1.9 D Eco (BA0A, BA0U, BA0R), RENAULT MEGANE I (BA0/1_) 1.6 i (BA0L), RENAULT MEGANE I (BA0/1_) 1.9 dT (B/SA0K, B/SA0Y), RENAULT MEGANE I (BA0/1_) 1.4 Eco (BA0T), RENAULT MEGANE I (BA0/1_) 2.0 16V (BA0H), RENAULT MEGANE I (BA0/1_) 1.9 TDI, RENAULT MEGANE I (BA0/1_) 1.9 dTi (BA08, BA0N), RENAULT MEGANE I (BA0/1_) 1.6 16V (BA04, BA0B, BA11, BA1J, BA16, BA19, BA1K, BA1V,..., RENAULT MEGANE I (BA0/1_) 1.4 16V (BA0D, BA1H, BA0W, BA10), RENAULT MEGANE I (BA0/1_) 1.9 dCi (BA05, BA1F), RENAULT MEGANE I (BA0/1_) 1.9 dTi (BA1U), RENAULT MEGANE I (BA0/1_) 1.8 16V (BA06, BA12, BA1A, BA1M, BA1R), RENAULT MEGANE I (BA0/1_) 1.9 D, RENAULT MEGANE I (BA0/1_) 1.9 DCi, RENAULT MEGANE I (BA0/1_) 1.6 LPG, RENAULT MEGANE I (BA0/1_) 1.6 LPG, RENAULT MEGANE I (BA0/1_) 2.0, RENAULT MEGANE I (BA0/1_) 1.9 dT … View more
The steps may slightly vary depending on the car design.
RENAULT MEGANE I (BA0/1_) 1.4 e (BA0E, BA0V), RENAULT MEGANE I (BA0/1_) 1.6 e (BA0F, BA0S), RENAULT MEGANE I (BA0/1_) 2.0 i (BA0G), RENAULT MEGANE I (BA0/1_) 1.9 D Eco (BA0A, BA0U, BA0R), RENAULT MEGANE I (BA0/1_) 1.6 i (BA0L), RENAULT MEGANE I (BA0/1_) 1.9 dT (B/SA0K, B/SA0Y), RENAULT MEGANE I (BA0/1_) 1.4 Eco (BA0T), RENAULT MEGANE I (BA0/1_) 2.0 16V (BA0H), RENAULT MEGANE I (BA0/1_) 1.9 TDI, RENAULT MEGANE I (BA0/1_) 1.9 dTi (BA08, BA0N), RENAULT MEGANE I (BA0/1_) 1.6 16V (BA04, BA0B, BA11, BA1J, BA16, BA19, BA1K, BA1V,..., RENAULT MEGANE I (BA0/1_) 1.4 16V (BA0D, BA1H, BA0W, BA10), RENAULT MEGANE I (BA0/1_) 1.9 dCi (BA05, BA1F), RENAULT MEGANE I (BA0/1_) 1.9 dTi (BA1U), RENAULT MEGANE I (BA0/1_) 1.8 16V (BA06, BA12, BA1A, BA1M, BA1R), RENAULT MEGANE I (BA0/1_) 1.9 D, RENAULT MEGANE I (BA0/1_) 1.9 DCi, RENAULT MEGANE I (BA0/1_) 1.6 LPG, RENAULT MEGANE I (BA0/1_) 1.6 LPG, RENAULT MEGANE I (BA0/1_) 2.0, RENAULT MEGANE I (BA0/1_) 1.9 dT … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for MEGANE I (BA0/1_) and other RENAULT models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Square oil drain plug socket No.8
Oil filter cup socket #74-15F
Oil filter cup socket #76-12F
Ratchet wrench
Funnel
Fender cover
Replacement: engine oil and filter – RENAULT MEGANE I (BA0/1_). AUTODOC experts recommend:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – RENAULT MEGANE I (BA0/1_) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Pull up the oil dipstick. - Step 4
Unscrew the oil filler plug. - Step 5Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – RENAULT MEGANE I (BA0/1_). AUTODOC experts recommend:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 6
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 7Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.Step 8
Unscrew the drain plug. Use square oil drain plug socket No.8 Use a ratchet wrench. - Step 9
Drain the used oil.Replacement: engine oil and filter – RENAULT MEGANE I (BA0/1_). Tip:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 10
Unscrew the oil filter. Use the 76/12-F socket. Use a ratchet wrench. - Step 11
Clean the oil filter seat. Use all-purpose cleaning spray. - Step 12
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 13
Screw the new filter into its place. Use the 74/15-F socket. Use a torque wrench. Tighten it to 20 nm torque. - Step 14
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray. - Step 15
Screw in the new drainage plug and tighten it. Use square oil drain plug socket No.8 Use a torque wrench. Tighten it to 28 nm torque. - Step 16
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the RENAULT Megane I Hatchback (BA) model
Popular maintenance tutorials for Renault Megane 1
Complete guides for changing the Oil filters on different RENAULT MEGANE models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your RENAULT MEGANE I (BA0/1_)
View more
How to remove rust | AUTODOC tips
Kolbenschmidt plastic gauge overview
Top 5 mistakes when replacing spark plugs | AUTODOC tips
How to repair a bumper yourself | AUTODOC tips
Most commonly replaced car parts on RENAULT MEGANE
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




























