Recommended replacement interval for the part category Oil filter : 2 year / 15000 km

Important!

This replacement procedure can be used for:
PEUGEOT BOXER Platform/Chassis (ZCT_) 1.9 D, PEUGEOT BOXER Platform/Chassis (ZCT_) 2.0, PEUGEOT BOXER Platform/Chassis (ZCT_) 1.9 TD, PEUGEOT BOXER Platform/Chassis (ZCT_) 1.9 TD, PEUGEOT BOXER Platform/Chassis (ZCT_) 2.0 i … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Oil filter

Replacement: engine oil and filter – PEUGEOT BOXER Platform/Chassis (ZCT_). Tools you'll need:

                      Wire brush
                    
                      All-purpose cleaning spray
                    
                      Torque wrench
                    
                      Combination spanner #22
                    
                      Oil filter cup socket 76/14-F
                    
                      Ratchet wrench
                    
                      Funnel
                    
                      Oil drain pan
                    
                      Fender cover

Buy tools

Replacement: engine oil and filter – PEUGEOT BOXER Platform/Chassis (ZCT_). AUTODOC experts recommend:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
All work should be done with the engine stopped.

Replacement: engine oil and filter – PEUGEOT BOXER Platform/Chassis (ZCT_). Use the following procedure:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Pull up the oil dipstick.

Step 4

Unscrew the oil filler plug.
Step 5

Lift the car using a jack or place it over an inspection pit.

AUTODOC recommends:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 6

Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 7

Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 8

Unscrew the drain plug. Use a combination spanner #22.
Step 9

Drain the used oil.

Replacement: engine oil and filter – PEUGEOT BOXER Platform/Chassis (ZCT_). Tip:
Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
Step 10

Clean the oil filter. Use all-purpose cleaning spray.

Step 11

Unscrew the oil filter. Use the 76/14-F socket. Use a ratchet wrench.
Step 12

Put the old oil filter in the container.
Step 13

Clean the oil filter seat. Use all-purpose cleaning spray.

Step 14

Screw the new filter into its place. Use the 76/14-F socket. Observe the recommended tightening torque.
Step 15

Clean the area of the oil pan drainage hole.
Step 16

Screw in the new drainage plug and tighten it. Use a combination spanner #22. Use a torque wrench. Tighten it to 30 nm torque.
Step 17

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 18

Lower the car.

Step 19

Remove the oil filler cap.
Step 20

Insert the funnel.

Step 21

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – PEUGEOT BOXER Platform/Chassis (ZCT_). Tip from AUTODOC experts:
Use the oil recommended by the manufacturer.
Step 22

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 23

Install the oil filler cap.
Step 24

Tighten the oil filler cap.

Step 25

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.

Step 26

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 27

Remove the fender protection cover.

Step 28

Close the hood.

Replacement: engine oil and filter – PEUGEOT BOXER Platform/Chassis (ZCT_). Tip from AUTODOC:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out.To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the PEUGEOT Boxer Platform / Chassis (230) model

PEUGEOT BOXER Platform/Chassis (ZCT_) tyre size

How to change serpentine belt on PEUGEOT Boxer Platform / Chassis (230) – replacement guide

Free download PDF
1.46 MB
How to change spark plugs on PEUGEOT BOXER Platform/Chassis (ZCT_) – replacement guide

Free download PDF
1.25 MB
How to change glow plugs on PEUGEOT BOXER Platform/Chassis (ZCT_) – replacement guide

Free download PDF
1.27 MB
How to change water pump & timing belt kit on Peugeot 307 SW – replacement guide

Free download PDF
7.01 MB
How to change engine oil and filter on Peugeot 308 I – replacement guide

Free download PDF
3.3 MB
How to change fuel filter on Peugeot 206 CC 2D – replacement guide

Free download PDF
1.12 MB

How to change engine oil and filter on PEUGEOT Boxer Van (250) – replacement guide

Free download PDF
3.11 MB
How to change engine oil and filter on PEUGEOT Boxer Platform / Chassis (250) – replacement guide

Free download PDF
3.11 MB
How to change engine oil and filter on PEUGEOT BOXER Box (230L) – replacement guide

Free download PDF
1.17 MB
How to change engine oil and filter on PEUGEOT Boxer Minibus (250) – replacement guide

Free download PDF
3.13 MB
How to change engine oil and filter on PEUGEOT BOXER Platform/Chassis (244) – replacement guide

Free download PDF
1.17 MB
How to change engine oil and filter on PEUGEOT BOXER Box (244) – replacement guide

Free download PDF
1.16 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Top 5 reasons why the suspension knocks | AUTODOC tips

2M views

Published on: 09/09/2022
Prevent Engine Damage: How to Identify Rocker Cover Gasket Issues and Proper Replacement | AUTODOC

6K views

Published on: 03/12/2020
TOP 6 WD-40 lifehacks | AUTODOC tips

13K views

Published on: 15/07/2021
Easy Steps to Fix Minor Scratches on Your Vehicle | AUTODOC tips

8K views

Published on: 12/05/2022