Disclaimer
How to change engine oil and filter on PEUGEOT 504 Estate – replacement guide
downloads:
2
Views:
103
Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
PEUGEOT 504 Break (D_, F_) 2.0, PEUGEOT 504 Break (D_, F_) 2.3 D (D40, F40), PEUGEOT 504 Break (D_, F_) 2.1 D (E20, F20), PEUGEOT 504 Break (D_, F_) 2.0 (D11, F11), PEUGEOT 504 Break (D_, F_) 1.8 (F01, E01) … View more
The steps may slightly vary depending on the car design.
PEUGEOT 504 Break (D_, F_) 2.0, PEUGEOT 504 Break (D_, F_) 2.3 D (D40, F40), PEUGEOT 504 Break (D_, F_) 2.1 D (E20, F20), PEUGEOT 504 Break (D_, F_) 2.0 (D11, F11), PEUGEOT 504 Break (D_, F_) 1.8 (F01, E01) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for 504 Break (D_, F_) and other PEUGEOT models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Combination spanner #22
Oil filter cup socket 76/14-F
Ratchet wrench
Funnel
Oil drain pan
Fender cover
Replacement: engine oil and filter – PEUGEOT 504 Break (D_, F_). AUTODOC experts recommend:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- All work should be done with the engine stopped.
Replacement: engine oil and filter – PEUGEOT 504 Break (D_, F_). Use the following procedure:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Pull up the oil dipstick.Step 4
Unscrew the oil filler plug. - Step 5Lift the car using a jack or place it over an inspection pit.AUTODOC recommends:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 6
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 7
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 8
Unscrew the drain plug. Use a combination spanner #22. - Step 9
Drain the used oil.Replacement: engine oil and filter – PEUGEOT 504 Break (D_, F_). Tip:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 10Clean the oil filter. Use all-purpose cleaning spray.Step 11
Unscrew the oil filter. Use the 76/14-F socket. Use a ratchet wrench. - Step 12
Put the old oil filter in the container. - Step 13Clean the oil filter seat. Use all-purpose cleaning spray.Step 14
Screw the new filter into its place. Use the 76/14-F socket. Observe the recommended tightening torque. - Step 15
Clean the area of the oil pan drainage hole. - Step 16
Screw in the new drainage plug and tighten it. Use a combination spanner #22. Use a torque wrench. Tighten it to 30 nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the PEUGEOT 504 Estate model
Popular maintenance tutorials for PEUGEOT 504 Break (D_, F_)
Complete guides for changing the Oil filters on different PEUGEOT 504 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your PEUGEOT 504 Break (D_, F_)
View more
Initial Car Inspection: What to Check Before You Buy
How to Prevent Premature Wear on Your Car Boot Damper | AUTODOC
Transform Your Car's Look: 6 Simple Accessories You Need to Try!
CHECK ENGINE light turned on – step-by-step guide on what to do
Most commonly replaced car parts on PEUGEOT 504
Time to replace parts? Get even better deals in our Shop app.

SCAN ME





























