Replacement: engine oil and filter – PEUGEOT 205 I Convertible (741B, 20D). AUTODOC experts recommend:
Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
All work should be done with the engine stopped.
Replacement: engine oil and filter – PEUGEOT 205 I Convertible (741B, 20D). Use the following procedure:
Step 1
Open the hood.
Step 2
Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
Step 3
Pull up the oil dipstick.
Step 4
Unscrew the oil filler plug.
Step 5
Lift the car using a jack or place it over an inspection pit.
AUTODOC recommends:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 6
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 7
Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 8
Unscrew the drain plug. Use a combination spanner #22.
Step 9
Drain the used oil.
Replacement: engine oil and filter – PEUGEOT 205 I Convertible (741B, 20D). Tip:
Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
Step 10
Clean the oil filter. Use all-purpose cleaning spray.
Step 11
Unscrew the oil filter. Use the 76/14-F socket. Use a ratchet wrench.
Step 12
Put the old oil filter in the container.
Step 13
Clean the oil filter seat. Use all-purpose cleaning spray.
Step 14
Screw the new filter into its place. Use the 76/14-F socket. Observe the recommended tightening torque.
Step 15
Clean the area of the oil pan drainage hole.
Step 16
Screw in the new drainage plug and tighten it. Use a combination spanner #22. Use a torque wrench. Tighten it to 30 nm torque.
Step 17
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 18
Lower the car.
Step 19
Remove the oil filler cap.
Step 20
Insert the funnel.
Step 21
Pour new oil into the engine in the amount recommended by the car manufacturer.
Replacement: engine oil and filter – PEUGEOT 205 I Convertible (741B, 20D). Tip from AUTODOC experts:
Use the oil recommended by the manufacturer.
Step 22
Check the oil level using the dipstick. Top up oil if necessary.
Please note!
The oil level should be between the Min and Max marks.
Step 23
Install the oil filler cap.
Step 24
Tighten the oil filler cap.
Step 25
Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.
Step 26
Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.
Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 27
Remove the fender protection cover.
Step 28
Close the hood.
Replacement: engine oil and filter – PEUGEOT 205 I Convertible (741B, 20D). Tip from AUTODOC:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out.To protect the environment from pollution, be sure to dispose of the used filters at special collection points.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Popular maintenance tutorials for Peugeot 205 Convertible
It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents
Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
Scan
To download the app:
- scan the QR code
- download from App Store
- download from Google Play
Tips & tricks for your PEUGEOT 205 I Convertible (741B, 20D)