
Disclaimer
How to change engine oil and filter on NISSAN PRIMERA Hatchback (P10) – replacement guide
downloads:
0
Views:
28

Recommended replacement interval for the part category Oil filter : 15000 km
Important!
This replacement procedure can be used for:
NISSAN PRIMERA Hatchback (P10) 2.0, NISSAN PRIMERA Hatchback (P10) 2.0, NISSAN PRIMERA Hatchback (P10) 2.0 i, NISSAN PRIMERA Hatchback (P10) 2.0 16V … View more
The steps may slightly vary depending on the car design.
NISSAN PRIMERA Hatchback (P10) 2.0, NISSAN PRIMERA Hatchback (P10) 2.0, NISSAN PRIMERA Hatchback (P10) 2.0 i, NISSAN PRIMERA Hatchback (P10) 2.0 16V … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for PRIMERA Hatchback (P10) and other NISSAN models
Oil filter
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 14
Oil filter cup socket 65-14F
Ratchet wrench
Funnel
Oil drain pan
Fender cover
Replacement: engine oil and filter – NISSAN PRIMERA Hatchback (P10). Tip:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- All work should be done with the engine stopped.
Replacement: engine oil and filter – NISSAN PRIMERA Hatchback (P10). Recommended sequence of steps:
- Step 1Open the bonnet.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Unscrew the oil filler plug.
- Step 4Pull up the oil dipstick.
- Step 5Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – NISSAN PRIMERA Hatchback (P10). AUTODOC recommends:The vehicle must be on a level surface, but if it is at an angle, the drain plug must be at the lowest point.Step 6Put a waste oil container with at least 4 l capacity under the drainage hole.
- Step 7Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
- Step 8Unscrew the drain plug. Use a drive socket #14. Use a ratchet wrench.
- Step 9Drain the used oil.AUTODOC recommends:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
- Step 10Clean the oil filter. Use all-purpose cleaning spray.Step 11Unscrew the oil filter. Use the 65-14F socket. Use a ratchet wrench.
- Step 12Remove the oil filter.
- Step 13Clean the oil filter seat. Use all-purpose cleaning spray.
- Step 14Lubricate the rubber seal of the new filter with a little amount of fresh oil.
- Step 15Install a new oil filter.
- Step 16Tighten the oil filter. Remember to observe the recommended tightening torque. Use the 65-14F socket. Use a torque wrench. Tighten it to 18 Nm torque.
- Step 17Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
- Step 18Screw in the new drainage plug and tighten it. Use a drive socket #14. Use a torque wrench. Tighten it to 28 Nm torque.
- Step 19Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the NISSAN Primera Hatchback (P10) model
Popular maintenance tutorials for Nissan Primera P10 Hatchback
Complete guides for changing the Oil filters on different NISSAN PRIMERA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your NISSAN PRIMERA Hatchback (P10)
View more
- Regain Your Confidence on the Road: Easy Headlight Restoration Tips
- TOP 5 mistakes during DIY oil change | AUTODOC tips
- Save Money on Fuel with These Easy Tips | AUTODOC
- How to Safely Wash Your Car in Winter Without Damage | AUTODOC tips
Most commonly replaced car parts on NISSAN PRIMERA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME