Disclaimer
How to change engine oil and filter on MERCEDES-BENZ E-Class T-modell (S124) – replacement guide
downloads:
0
Views:
5
Recommended replacement interval for the part category Oil filter : 1 year / 15000 km
Important!
This replacement procedure can be used for:
MERCEDES-BENZ E-Class T-modell (S124) E 300 T 4-matic (124.290) … View more
The steps may slightly vary depending on the car design.
MERCEDES-BENZ E-Class T-modell (S124) E 300 T 4-matic (124.290) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for E-Class T-modell (S124) and other MERCEDES-BENZ models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 13
Drive socket # 19
Oil filter cup socket 76/14F
Ratchet wrench
Funnel
Oil drain pan
Fender cover
Replacement: engine oil and filter – MERCEDES-BENZ E-CLASS Estate (S124). AUTODOC experts recommend:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Warning! Shut down the engine before starting any work – MERCEDES-BENZ E-CLASS Estate (S124).
Carry out replacement in the following order:
- Step 1Open the bonnet.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4
Pull up the oil dipstick. - Step 5Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – MERCEDES-BENZ E-CLASS Estate (S124). Tip:The vehicle must be on a level surface, but if it is at an angle, the drain plug must be at the lowest point.Step 6
Put a waste oil container with at least 6 l capacity under the drainage hole. - Step 7
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 8
Unscrew the drain plug. Use a drive socket #19. Use a ratchet wrench. - Step 9
Drain the used oil.AUTODOC recommends:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 10Clean the oil filter. Use all-purpose cleaning spray.Step 11
Unscrew the oil filter. Use the 76/14F socket. Use a ratchet wrench. - Step 12
Remove the oil filter. - Step 13Clean the oil filter seat. Use all-purpose cleaning spray.Step 14
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 15
Install a new oil filter. - Step 16
Tighten the oil filter. Remember to observe the recommended tightening torque. Use the 76/14F socket. Use a torque wrench. Tighten it to 20 Nm torque. - Step 17
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray. - Step 18
Screw in the new drainage plug and tighten it. Use a drive socket #13. Use a torque wrench. Tighten it to 27 Nm torque. - Step 19
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the MERCEDES-BENZ E-Class T-modell (S124) model
Popular maintenance tutorials for Mercedes S124
Complete guides for changing the Oil filters on different MERCEDES-BENZ E-CLASS models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your MERCEDES-BENZ E-Class T-modell (S124)
View more
K2 ROTON wheel cleaner overview
Top 5 reasons why the suspension knocks | AUTODOC tips
How to easily repair a punctured tyre | AUTODOC tips
Save Money on Fuel with These Easy Tips | AUTODOC
Most commonly replaced car parts on MERCEDES-BENZ E-CLASS
Time to replace parts? Get even better deals in our Shop app.

SCAN ME





























