Disclaimer
How to change engine oil and filter on DACIA Duster II – replacement guide
downloads:
89
Views:
1325
Recommended replacement interval for the part category Oil filter : 1 year / 20000 km
Important!
This replacement procedure can be used for:
DACIA Duster II 1.6 SCe 115 LPG (HMM1), DACIA Duster II 1.6 SCe 115 4x4 (HMM1), DACIA Duster II 1.6 SCe 115 (HMM1) … View more
The steps may slightly vary depending on the car design.
DACIA Duster II 1.6 SCe 115 LPG (HMM1), DACIA Duster II 1.6 SCe 115 4x4 (HMM1), DACIA Duster II 1.6 SCe 115 (HMM1) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for Duster II and other DACIA models
Alternative products

Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 14
Oil filter cup socket 65-14F
Ratchet wrench
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – DACIA DUSTER. AUTODOC experts recommend:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – DACIA DUSTER – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Pull up the oil dipstick. - Step 4
Unscrew the oil filler plug. - Step 5Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – DACIA DUSTER. Professionals recommend:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 6
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 7
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 8
Unscrew the drain plug. Use a drive socket #14. Use a ratchet wrench. - Step 9
Drain the used oil.Replacement: engine oil and filter – DACIA DUSTER. Tip from AUTODOC:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 10
Clean the oil filter. Use all-purpose cleaning spray. - Step 11
Unscrew the oil filter. Use the 65-14F socket. Use a ratchet wrench. - Step 12
Remove the oil filter. - Step 13
Clean the oil filter seat. Use all-purpose cleaning spray. - Step 14
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 15
Install a new oil filter. - Step 16
Tighten the oil filter. Remember to observe the recommended tightening torque. Use the 65-14F socket. Use a torque wrench. Tighten it to 24 Nm torque. - Step 17
Clean the oil filter. Use all-purpose cleaning spray. - Step 18
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray. - Step 19
Screw in the new drainage plug and tighten it. Use a drive socket #14. Use a torque wrench. Tighten it to 30 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the DACIA Duster II model
Popular maintenance tutorials for Dacia Duster 2
Complete guides for changing the Oil filters on different DACIA DUSTER models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your DACIA Duster II
View more
How I started restoring a driveshaft | Drivetrain restoration – Part 1
What to do if your car’s bonnet won’t open | AUTODOC tips
5 most common causes of oil leaks | AUTODOC tips
5 tools that make car repair incredibly simple | AUTODOC tips
Most commonly replaced car parts on DACIA DUSTER
Time to replace parts? Get even better deals in our Shop app.

SCAN ME
























