Disclaimer
How to change engine oil and filter on AUDI 80 F103 Saloon – replacement guide
downloads:
0
Views:
3
Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
AUDI 80 F103 Saloon 1.7 … View more
The steps may slightly vary depending on the car design.
AUDI 80 F103 Saloon 1.7 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for 80 F103 Saloon and other AUDI models
Alternative products

Wire brush
All-purpose cleaning spray
Oil filter cup socket 76-14F
Drive socket # 19
Torx bit T20
Combination spanner #19
Ratchet wrench
Torque wrench
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – AUDI 80 F103 Limousine. Tip from AUTODOC experts:
- Replace the oil filter every time when changing motor oil.
- Use only new O-rings during installation.
- Wear gloves to prevent contact with hot liquid.
- All work should be done with the engine stopped.
Replacement: engine oil and filter – AUDI 80 F103 Limousine. Take the following steps:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Unscrew the oil filler plug. - Step 4Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – AUDI 80 F103 Limousine. AUTODOC recommends:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Step 5
Undo the fasteners of the oil pan lower cover. Use Torx T20. Use a ratchet wrench. - Step 6
Remove the oil pan cover. - Step 7
Put a waste oil container with at least 5 l capacity under the drainage hole. - Step 8
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 9
Unscrew the drain plug. Use a combination spanner #19. - Step 10
Drain the used oil.Replacement: engine oil and filter – AUDI 80 F103 Limousine. Tip from AUTODOC:Caution! The oil may be hot. - Step 11
Clean the oil filter seat. Use all-purpose cleaning spray. - Step 12Prepare a container for the old oil filter.Step 13
Unscrew the oil filter. Use the 76-14F socket. Use a ratchet wrench. - Step 14
Put the old oil filter in the container.Replacement: engine oil and filter – AUDI 80 F103 Limousine. Tip from AUTODOC experts:Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter. - Step 15
Clean the oil filter seat. - Step 16
Lubricate the rubber seal of the new filter with a little amount of fresh oil. - Step 17
Screw the new filter into its place. Use the 76-14F socket. Use a torque wrench. Tighten it to 18 Nm torque.Replacement: engine oil and filter – AUDI 80 F103 Limousine. Professionals recommend:Wait until the oil has completely drained from the drainage hole. - Step 18
Clean the area of the oil pan drainage hole.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the AUDI 80 F103 Saloon model
Popular maintenance tutorials for AUDI 80 F103 Limousine
Complete guides for changing the Oil filters on different AUDI 80 models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your AUDI 80 F103 Saloon
View more
How to get your motorcycle ready for spring
How I started restoring a driveshaft | Drivetrain restoration – Part 1
How to prevent car windows from fogging up | AUTODOC tips
Top 5 Mistakes to Avoid for Safe Engine Bay Repairs | AUTODOC Tips
Most commonly replaced car parts on AUDI 80
Time to replace parts? Get even better deals in our Shop app.

SCAN ME































