The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All works should be done with the engine cooled down.
Step 5
Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 6
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 7
Unscrew the drain plug. Use Torx T50. Use a ratchet wrench.
Clean the oil filter. Use all-purpose cleaning spray.
Step 10
Unscrew the oil filter. Use the 76-12F socket. Use a ratchet wrench.
Step 11
Remove the oil filter.
Replacement: engine oil and filter – Alfa Romeo 147 937. Tip from AUTODOC:
Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Step 12
Clean the oil filter seat. Use all-purpose cleaning spray.
Step 13
Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 14
Install a new oil filter.
Step 15
Tighten the oil filter. Remember to observe the recommended tightening torque. Use the 76-12F socket. Use a torque wrench. Tighten it to 18 Nm torque.
AUTODOC recommends:
Wait until the oil has completely drained from the drainage hole.
Step 16
Clean the area of the oil pan drainage hole.
Step 17
Screw in the new drainage plug and tighten it. Use Torx T50. Use a torque wrench. Tighten it to 20 nm torque.
Step 18
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 19
Lower the car.
Step 20
Remove the oil filler cap.
Step 21
Insert the funnel.
Step 22
Pour oil into the engine through the filler. Required amount of oil: 4 l.
Replacement: engine oil and filter – Alfa Romeo 147 937. Tip from AUTODOC:
Use the oil recommended by the manufacturer.
Step 23
Check the oil level using the dipstick. Top up oil if necessary.
Please note!
The oil level should be between the Min and Max marks.
Step 24
Install the oil filler cap.
Step 25
Tighten the oil filler cap.
Step 26
Run the engine for a few minutes.
Step 27
After the oil pressure warning light goes out, stop the engine.
Step 28
Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.
Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 1
Searching for the right tyres?
Find out which tyre and wheel sizes are compatible with the ALFA ROMEO 147 (937) model.
It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents
Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
Scan
To download the app:
- scan the QR code
- download from App Store
- download from Google Play
Tips & tricks for your ALFA ROMEO 147 (937)
View more
Easy Steps to Fix Minor Scratches on Your Vehicle | AUTODOC tips
How to Get the Best Deals on Car Parts | Save Money with AUTODOC
Top 5 mistakes when replacing spark plugs | AUTODOC tips
5 tools that make car repair incredibly simple | AUTODOC tips
Most commonly replaced car parts on ALFA ROMEO 147